SC3445 データシートの表示（PDF） - Silan Microelectronics
部品番号
コンポーネント説明
メーカー
SC3445 Datasheet PDF : 33 Pages
| |||
Silan
Semiconductors
SC3445
To power off, however, when power off occurs by a 2ndF OFFB, signs of
are not
preserved.
4) When an error occurs, to prevent the calculation from continuing all keys except for the ON/C OFF
keys are ignored. (However if the error occurred because calculation priority saves could not be done
even though they were within the 6 levels then the error condition is 4) and the CE key may be used to
clear the error and continue the calculation.)
(6). Automatic power off
* If after pressing a key, another is not pressed for about 8 minutes the power is automatically shut off,
however, going on pressing ON/C key, the power is not shut off.
* All contents are preserved as they were just prior to power off.
(7). TAB (Decimal digit display) function
See the section on the decimal digit display key
(Example)
5
÷
9
=
→
2ndF
TAB
2
→
2ndF
TAB
5
→
2ndF
TAB
1
→
F–E
→
ON/C
→
2ndF
TAB
Ȏ
→
0.555555556
0.56
0. 5 5 5 6
0.6
0.6–0.1
0.0
0.
* As a rule, once the number of decimal digits to be displayed is set it does not change until it is reset.
* Setting or clearing statistical mode, doing 2ndF CAD in statistical mode, or pressing ON/C after OFF
sets floating point mode.
* Using storage memory K1 to save low priority calculations causes the decimal digit display to be cleared
and go to floating point mode.
(8). Auto- clear function
* When the LSI has power applied to it all memory contents and modes are cleared, degree units are
selected and floating point mode is selected. (This is not the same as the ON/C power on)
HANGZHOU SILAN MICROELECTRONICS JOINT-STOCK CO.,LTD
Rev: 1.0
2001.06.11
20
Share Link: 