47648-000LF データシートの表示（PDF） - First Components International

部品番号

コンポーネント説明

メーカー

47648-000LF

Basics+,Mini-PV™ : 2.54 x 2.54 mm (0.1 x 0.1 in.) Centerline Crimp-to-Wire PV Receptacle Housing, Double Row

First Components International 

TYPE

PRODUCT SPECIFICATION

NUMBER

BUS-12-067

TITLE

Crimp-to Wire, Mini-PV™ Receptacles and Mini-Latch Housings

9.5 Acceptance

PAGE

REVISION

14 of 16

K

AUTHORIZED BY

DATE

H.T. Brewbaker 31-May-06

CLASSIFICATION

UNRESTRICTED

9.5.1 Electrical and mechanical requirements placed on test samples as indicated in paragraphs 6.0

and 7.0 shall be established from test data using appropriate statistical techniques or shall

otherwise be customer specified,and all samples tested in accordance with this product

specification shall meet the stated requirements.

9.5.2 Failures attributed to equipment, test setup, or operator error shall not disqualify the product. If

product failure occurs, corrective action shall be taken and samples resubmitted for qualification.

9.6 Qualification Testing

Qualification testing shall be performed on sample units produced with equipment and procedures

normally used in production. The test sequence shall be as shown in Table VI.

9.7 Requalification Testing

If any of the following conditions occur, the responsible product engineer shall initiate requalification

testing consisting of all applicable parts of the qualification test matrix, Table VI.

a. A significant design change is made to the existing product which impacts the product form, fit or

function. Examples of significant changes shall include, but not be limited to, changes in the

plating material composition or thickness, contact force, contact surface geometry, contact base

material, or contact lubrication requirements.

b. A significant change is made to the manufacturing process which impacts the product form, fit or

function.

c. A significant event occurs during production or end use requiring corrective action to be taken

relative to the product design or manufacturing process.

Copyright FCI

Form E-3334

Rev E

PDM: Rev:K

GS-01-001

STATUS:Released Printed: Nov 28, 2010.

Share Link: