MAX3095CSE データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
MAX3095CSE Datasheet PDF : 11 Pages
| |||
±15kV ESD-Protected, 10Mbps, 3V/5V,
Quad RS-422/RS-485 Receivers
ABSOLUTE MAXIMUM RATINGS
Supply Voltage (VCC) ...............................................................7V
Control Input Voltage (G, G).......................-0.3V to (VCC + 0.3V)
Receiver Input Voltage (A_, B_)...........................................±25V
Receiver Output Voltage (Y_).....................-0.3V to (VCC + 0.3V)
Continuous Power Dissipation (TA = +70°C)
16-Pin Plastic DIP (derate 10.5mW/°C above +70°C) .762mW
16-Pin SO (derate 8.7mW/°C above +70°C)................696mW
16-Pin QSOP (derate 8.3mW/°C above +70°C)...........667mW
Operating Temperature Ranges
MAX309_C_ _ .....................................................0°C to +70°C
MAX309_E_ _...................................................-40°C to +85°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
DC ELECTRICAL CHARACTERISTICS—MAX3095
(VCC = 5V ±5%, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
Receiver Differential Input
Threshold
VTH -7V ≤ VCM ≤ 12V
Receiver Input Hysteresis
VCM = 0V
Receiver Input Current (A_, B_)
IIN
VCC = 0V or 5.25V
Enable Input Current (G, G)
Enable Input High Voltage (G, G)
VIH
Enable Input Low Voltage (G, G)
VIL
VIN = 12V
VIN = -7V
Receiver Output High Voltage
VOH
IOUT = -4mA, VID = 200mV,
G = VCC or G = GND, Figure 1
Receiver Output Low Voltage
VOL
IOUT = 4mA, VID = -200mV,
G = VCC or G = GND, Figure 1
Three-State Current at Receiver
Output
IOZR
0 ≤ VOUT ≤ VCC, G = GND and G = VCC
Output Short-Circuit Current
Receiver Input Resistance
Supply Current
ESD Protection
(Note 2)
IOSR
RIN
ICC
0 ≤ VOUT ≤ VCC, G = VCC or G = GND
-7V ≤ VCM ≤ 12V
No load, G = VCC or G = GND
G = GND and G = VCC
Human Body Model
IEC1000-4-2 (Air-Gap Discharge)
IEC1000-4-2 (Contact Discharge)
MIN TYP
-200
45
2.0
VCC - 1.5
±7
48
2.4
0.001
±15
±15
±8
MAX UNITS
200
mV
mV
250
µA
-200
±1
µA
V
0.8
V
V
0.4
V
±1
µA
±75 mA
kΩ
3.5
mA
10
µA
kV
2 _______________________________________________________________________________________
Share Link: 