MX25L4005MC-15G データシートの表示（PDF） - Macronix International
部品番号
コンポーネント説明
メーカー
MX25L4005MC-15G Datasheet PDF : 41 Pages
| |||
MX25L4005
(14) Read Electronic Manufacturer ID & Device ID (REMS)
The REMS instruction is an alternative to the Release from Power-down/Device ID instruction that provides both the JEDEC
assigned manufacturer ID and the specific device ID.
The REMS instruction is very similar to the Release from Power-down/Device ID instruction. The instruction is initiated
by driving the CS# pin low and shift the instruction code "90h" followed by two dummy bytes and one bytes address (A7~A0).
After which, the Manufacturer ID for MXIC (C2h) and the Device ID are shifted out on the falling edge of SCLK with most
significant bit (MSB) first as shown in figure 25. The Device ID values are listed in Table of ID Definitions on page 16. If
the one-byte address is initially set to 01h, then the device ID will be read first and then followed by the Manufacturer ID.
The Manufacturer and Device IDs can be read continuously, alternating from one to the other. The instruction is completed
by driving CS# high.
Table of ID Definitions:
RDID Command
RES Command
REMS Command
manufacturer ID
memory type
memory density
C2
20
13
electronic ID
12
manufacturer ID
device ID
C2
12
P/N: PM1236
REV. 1.1, SEP. 30, 2005
16
Share Link: 