MAX3421EEHJ(2006) データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

メーカー

MAX3421EEHJ
(Rev.:2006)

USB Peripheral/Host Controller with SPI Interface

Maxim Integrated 

USB Peripheral/Host Controller

with SPI Interface

PIN

1

2

3, 19

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

20

Pin Description

NAME

GPIN7

VL

GND

GPOUT0

GPOUT1

GPOUT2

GPOUT3

GPOUT4

GPOUT5

GPOUT6

GPOUT7

RES

INPUT/

OUTPUT

FUNCTION

Input General-Purpose Input. GPIN7–GPIN0 are connected to VL with internal pullup resistors.

GPIN7–GPIN0 logic levels are referenced to the voltage on VL.

Input

Input

Level-Translator Voltage Input. Connect VL to the system’s 1.4V to 3.6V logic-level power

supply. Bypass VL to ground with a 0.1µF capacitor as close to VL as possible.

Ground

Output

General-Purpose Push-Pull Outputs. GPOUT7–GPOUT0 logic levels are referenced to the

voltage on VL.

Input

Device Reset. Drive RES low to clear all of the internal registers except for PINCTL (R17),

USBCTL (R15), and SPI logic. The logic level is referenced to the voltage on VL. (See the

Device Reset section for a description of resets available on the MAX3421E.)

SCLK

Input

SPI Serial-Clock Input. An external SPI master supplies SCLK with frequencies up to 26MHz.

The logic level is referenced to the voltage on VL. Data is clocked into the SPI slave interface

on the rising edge of SCLK. Data is clocked out of the SPI slave interface on the falling edge of

SCLK.

SPI Slave Select Input. The SS logic level is referenced to the voltage on VL. When SS is driven

SS

high, the SPI slave interface is not selected, the MISO pin is high impedance, and SCLK

Input transitions are ignored. An SPI transfer begins with a high-to-low SS transition and ends with a

low-to-high SS transition.

MISO

MOSI

Output

SPI Serial-Data Output (Master-In Slave-Out). MISO is a push-pull output. MISO is tri-stated in

half-duplex mode or when SS = 1. The MISO logic level is referenced to the voltage on VL.

Input or

Input/

Output

SPI Serial-Data Input (Master-Out Slave-In). The logic level on MOSI is referenced to the

voltage on VL. MOSI can also be configured as a bidirectional MOSI/MISO input and output.

(See Figure 15.)

GPX

Output

General-Purpose Multiplexed Push-Pull Output. The internal MAX3421E signal that appears on

GPX is programmable by writing to the GPXB and GPXA bits of the PINCTL (R17) register and

the SEPIRQ bit of the MODE (R27) register. GPX indicates one of five signals (see the GPX

section).

Interrupt Output. In edge mode, the logic level on INT is referenced to the voltage on VL and is

INT

Output a push-pull output with programmable polarity. In level mode, INT is open-drain and active low.

Set the IE bit in the CPUCTL (R16) register to enable INT.

D-

Input/ USB D- Signal. Connect D- to a USB connector through a 33Ω ±1% series resistor. A

Output switchable 15kΩ D- pulldown resistor is internal to the device.

_______________________________________________________________________________________ 5

Share Link: