DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

82574L データシートの表示(PDF) - Intel

部品番号
コンポーネント説明
メーカー
82574L Datasheet PDF : 472 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
Pin Interface—82574 GbE Controller
2.3.3
System Management Bus (SMBus) Interface
Table 9.
Note:
2.3.4
SMBus Interface
Symbol
SMB_DAT
SMB_CLK
SMB_ALRT_N
Lead #
Type
36
T/s, o/d
34
T/s, o/d
35
T/s, o/d
Op Mode
Name and Function
Bi-dir
Bi-dir
Output
SMBus Data
Stable during the high period of the clock (unless it
is a start or stop condition).
SMBus Clock
One clock pulse is generated for each data bit
transferred.
SMBus Alert
Acts as an interrupt pin of a slave device on the
SMBus in pass-through mode.
If the SMBus is disconnected, an external pull-up should be used for these pins, unless
it is guaranteed that manageability is disabled in the 82574.
NC-SI and Testability
Table 10.
NC-SI and Testability
Symbol
NC_SI_CLK_IN
NC_SI_CRS_DV
NC_SI_RXD0
NC_SI_RXD1
NC_SI_TX_EN
NC_SI_TXD0
NC_SI_TXD1
TEST_EN
Lead #
Type
Op
Mode
Name and Function
NC-SI Reference Clock Input
Synchronous clock reference for receive, transmit, and control
2
NC-SI_
in
Input
interface. This signal is a 50 MHz clock +/- 50 ppm.
Note: If not used, should have an external pull-down resistor.
Also, this clock is in addition to and separate from the XTAL
clock.
3
NC-SI_
out
Output
NC-SI Carrier Sense/Receive Data Valid (CRS/DV).
6
NC-SI_
out
Output
NC-SI Receive Data 0
Data signals to the Manageability Controller (MC).
5
NC-SI_
out
Output
NC-SI Receive Data 1
Data signals to the MC.
7
NC-SI_
in
Input
NC-SI Transmit Enable
Note: If not used, should have an external pull-down resistor.
9
NC-SI_
in
Input
NC-SI Transmit Data 0
Data signals from the MC
Note: If not used, should have an external pull-up resistor.
NC-SI Transmit Data 1
8
NC-SI_
in
Input
Data signal from the MC
Note: If not used, should have an external pull-up resistor.
Enables Test Mode
Test pins are overloaded on the functional signals as described
29
In
Input
in the pin description text of this section. The pin is active
high.
Note: This pin should be externally pulled down for normal
operation.
21

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]