B1204CC データシートの表示（PDF） - Teccor Electronics
部品番号
コンポーネント説明
メーカー
B1204CC Datasheet PDF : 212 Pages
| |||
Compak Two-chip SIDACtor Device
Compak Two-chip SIDACtor Device
The modified DO-214AA SIDACtor device provides low-cost, longitudinal protection.
1
(T)
3
(R)
2
(G)
SIDACtor devices are used to enable equipment to meet various regulatory requirements
including GR 1089, ITU K.20, K.21, and K.45, IEC 60950, UL 60950, and TIA-968 (formerly
known as FCC Part 68).
Electrical Parameters
Part
Number
P3002CA
P6002CA
VDRM
Volts
VS
Volts
Pins1-2, 2-3
140
180
275
350
VDRM
Volts
VS
Volts
Pins 1-3
280
360
550
700
VT
Volts
4
4
IDRM
µAmps
5
5
IS
mAmps
800
800
IT
Amps
1
1
IH
mAmps
120
120
CO
pF
Pins 1-3
15
15
* For surge ratings, see table below.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.
• IPP is a repetitive surge rating and is guaranteed for the life of the product.
• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• VDRM is measured at IDRM.
• VS is measured at 100 V/µs.
• Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.
• Off-state capacitance is measured between Pins 1-3 at 1 MHz with a 2 V bias.
• UL 60950 creepage requirements must be considered.
Surge Ratings
Series
A
IPP
2x10 µs
Amps
150
IPP
8x20 µs
Amps
150
IPP
10x160 µs
Amps
90
IPP
10x560 µs
Amps
50
IPP
10x1000 µs
Amps
45
ITSM
60 Hz
Amps
20
di/dt
Amps/µs
500
http://www.teccor.com
+1 972-580-7777
2 - 12
© 2002 Teccor Electronics
SIDACtor® Data Book and Design Guide
Share Link: 