AP2171FM データシートの表示（PDF） - Diodes Incorporated.

部品番号

コンポーネント説明

メーカー

AP2171FM

1A SINGLE CHANNEL CURRENT-LIMITED POWER SWITCH

Diodes Incorporated. 

AP2161/ AP2171

Application Information (cont.)

Under-Voltage Lockout (UVLO)

Under-voltage lockout function (UVLO) keeps the internal power switch from being turned on until the power supply has reached at least 1.9V, even

if the switch is enabled. Whenever the input voltage falls below approximately 1.9V, the power switch is quickly turned off. This facilitates the design

of hot-insertion systems where it is not possible to turn off the power switch before input power is removed.

Host/Self-Powered And Bus-Powered HUBs

Hosts and self-powered hubs have a local power supply that powers the embedded functions and the downstream ports (see Figure 2). This power

supply must provide from 5.25V to 4.75V to the board side of the downstream connection under full-load and no-load conditions. Hosts and SPHs

are required to have current-limit protection and must report over-current conditions to the USB controller. Typical SPHs are desktop PCs, monitors,

printers, and stand-alone hubs.

Figure 2 Typical One-Port USB Host / Self-Powered Hub

Generic Hot-Plug Applications

In many applications it may be necessary to remove modules or pc boards while the main unit is still operating. These are considered hot-plug

applications. Such implementations require the control of current surges seen by the main power supply and the card being inserted. The most

effective way to control these surges is to limit and slowly ramp the current and voltage being applied to the card, similar to the way in which a

power supply normally turns on. Due to the controlled rise times and fall times of the AP2161/AP2171, these devices can be used to provide a

softer start-up to devices being hot-plugged into a powered system. The UVLO feature of the AP2161/AP2171 also ensures that the switch is off

after the card has been removed, and that the switch is off during the next insertion.

By placing the AP2161/AP2171 between the VCC input and the rest of the circuitry, the input power reaches these devices first after insertion. The

typical rise time of the switch is approximately 1ms, providing a slow voltage ramp at the output of the device. This implementation controls system

surge current and provides a hot-plugging mechanism for any device.

AP2161/ AP2171

Document number: DS31564 Rev. 7 - 2

11 of 18

www.diodes.com

March 2013

© Diodes Incorporated

Share Link: