AT88SC153 データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT88SC153

3 x 64 x 8 Secure Memory with Authentication

Atmel Corporation 

Read Fuses

Write Fuses

1016D–SMEM–04/04

AT88SC153

The data byte address lower three bits are internally incremented following the receipt of

each data byte. The higher data byte address bits are not incremented, retaining the 8-

byte write page address. Each data byte within a page must only be loaded once. Once

a stop condition is issued to indicate the end of the host’s write operation, the device ini-

tiates the internal nonvolatile write cycle. An ACK polling sequence can be initiated

immediately. After a write command, if the host is not allowed to write at some address

locations, a nonvolatile write cycle will still be initiated, but the device will only modify

data at the allowed addresses. When write lock mode is enabled (WLM = “0”), the write

cycle is initiated automatically after the first data byte has been transmitted.

Figure 6. Read Fuses

0

Note: Fx = 1: fuse is not blown

Fx = 0: fuse is blown

The Read Fuses operation is always allowed. The AT88SC153 will continuously trans-

mit the fuse byte if the host continues to transmit an ACK. The command is terminated

when the host transmits a NACK and STOP bit.

Figure 7. Write Fuses

S

T

S

A

T

R

O

T

P

Note:

nnn = 001 : Blow FAB

nnn = 010 : Blow CMA

nnn = 100 : Blow PER

The Write Fuses operation is only allowed under secure code control; no data byte is

transmitted by the host. The fuses are blown sequentially: CMA is blown if FAB is equal

to “0”, and PER is blown if CMA is equal to “0”. If the fuses are all “0”s, the operation is

canceled and the device waits for a new command.

Once a stop condition is issued to indicate the end of the host’s write operation, the

device initiates the internal nonvolatile write cycle. An ACK polling sequence can be ini-

tiated immediately.

11

Share Link: