ATMEGA6450-16AI(2004) データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATMEGA6450-16AI
(Rev.:2004)

8-bit Microcontroller with In-System Programmable Flash

Atmel Corporation 

ATmega325/3250/645/6450

Assembly Code Example

EEPROM_read:

; Wait for completion of previous write

sbic EECR,EEWE

rjmp EEPROM_read

; Set up address (r18:r17) in address register

out EEARH, r18

out EEARL, r17

; Start eeprom read by writing EERE

sbi EECR,EERE

; Read data from Data Register

in r16,EEDR

ret

C Code Example

unsigned char EEPROM_read(unsigned int uiAddress)

{

/* Wait for completion of previous write */

while(EECR & (1<<EEWE))

;

/* Set up address register */

EEAR = uiAddress;

/* Start eeprom read by writing EERE */

EECR |= (1<<EERE);

/* Return data from Data Register */

return EEDR;

}

EEPROM Write During Power-

down Sleep Mode

When entering Power-down sleep mode while an EEPROM write operation is active, the

EEPROM write operation will continue, and will complete before the Write Access time

has passed. However, when the write operation is completed, the clock continues run-

ning, and as a consequence, the device does not enter Power-down entirely. It is

therefore recommended to verify that the EEPROM write operation is completed before

entering Power-down.

Preventing EEPROM

Corruption

During periods of low VCC, the EEPROM data can be corrupted because the supply volt-

age is too low for the CPU and the EEPROM to operate properly. These issues are the

same as for board level systems using EEPROM, and the same design solutions should

be applied.

An EEPROM data corruption can be caused by two situations when the voltage is too

low. First, a regular write sequence to the EEPROM requires a minimum voltage to

operate correctly. Secondly, the CPU itself can execute instructions incorrectly, if the

supply voltage is too low.

EEPROM data corruption can easily be avoided by following this design

recommendation:

Keep the AVR RESET active (low) during periods of insufficient power supply voltage.

This can be done by enabling the internal Brown-out Detector (BOD). If the detection

23

2570A–AVR–09/04

Share Link: