ATTINY87 データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATTINY87

8-bit Microcontroller with 8K/16K Bytes In-System Programmable Flash and LIN Controller

Atmel Corporation 

ATtiny87/ATtiny167

The calibrated Oscillator is used to time the EEPROM accesses. Make sure the Oscillator fre-

quency is within the requirements described in “OSCCAL – Oscillator Calibration Register” on

page 37.

The following code examples show one assembly and one C function for erase, write, or

atomic write of the EEPROM. The examples assume that interrupts are controlled (e.g., by

disabling interrupts globally) so that no interrupts will occur during execution of these

functions.

Assembly Code Example

EEPROM_write:

; Wait for completion of previous write

sbic EECR,EEPE

rjmp EEPROM_write

; Set Programming mode

ldi r16, (0<<EEPM1)|(0<<EEPM0)

out EECR, r16

; Set up address (r18:r17) in address register

out EEARH, r18

out EEARL, r17

; Write data (r16) to data register

out EEDR, r16

; Write logical one to EEMPE

sbi EECR,EEMPE

; Start eeprom write by setting EEPE

sbi EECR,EEPE

ret

C Code Example

void EEPROM_write(unsigned char ucAddress, unsigned char ucData)

{

/* Wait for completion of previous write */

while(EECR & (1<<EEPE))

;

/* Set Programming mode */

EECR = (0<<EEPM1)|(0<<EEPM0);

/* Set up address and data registers */

EEAR = ucAddress;

EEDR = ucData;

/* Write logical one to EEMPE */

EECR |= (1<<EEMPE);

/* Start eeprom write by setting EEPE */

EECR |= (1<<EEPE);

}

19

8265A–AVR–08/10

Share Link: