DMC73C168 データシートの表示（PDF） - Daewoo Semiconductor

部品番号

コンポーネント説明

メーカー

DMC73C168

8Bit Single Chip Microcontroller

Daewoo Semiconductor 

8Bit Single Chip Microcontroller

12

DMC73C168

4.1 Register File (RF)

The 256-byte on chip RAM resides in location >0000 to >00FF (‘>’ means hex) of the DMC73C168’s

address space and is called the Register File (RF). The RAM is treated as registers by much of the

instruction set and numbered R0-R255. The first two registers, R0 and R1, are also called the A and

B registers respectively. Several instructions specify A or B as either the source or destination

register ; e.g., STSP stores the contents of the Stack Pointer (SP) in the B register.

Except where stated otherwise, any register in the Register File can be addressed as an 8-bit source or

destination register. The stack is also located in the Register File. Refer to section 4.3 for information

regarding the initialization of the Stack Pointer (SP) and stack definition in the Register File.

4.2 Peripheral File (PF)

The Peripheral File (PF) resides in location >0100 to >0132 of the DMC73C168’s address space.

Peripheral File locations are numbered P0-P50. The PF registers are used for interrupt control, parallel

I/O, timer control, PLL, IF counter, BEEP, SIO and A/D converter control.

4.3 Peripheral RAM File (PRF)

The Peripheral RAM file (PRF) resides in location >0140 to >01BF of DMC73C168’s address space.

PRF will act a role P64-P191. Useage is for additional RAM, but addressing method is same as

Peripheral File’s.

Memory address

>0100

>0132

>0133

>013F

>0140

>01BF

>01C0

>01FF

P0

:

P50

P51

:

P63

P64

:

P191

P192

:

P255

Peripheral File

Not Avail

128 bytes PRF

Not Avail

Table 4.3 DMC73C168 Peripheral File Map

£Ä£Á£Å£×£Ï£Ï

DAEWOO ELECTRONICS CO., LTD.

Share Link: