EL4089 データシートの表示（PDF） - Intersil
部品番号
コンポーネント説明
メーカー
EL4089 Datasheet PDF : 9 Pages
| |||
EL4089
Absolute Maximum Ratings (TA = 25°C)
Voltage between V+ and V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . .33V
Voltage between VIN+, S/HIN+,and GND pins . . (V+) +0.5V to (V-) -0.5V
VOUT Current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60mA
Current into VIN- and HOLD Pins . . . . . . . . . . . . . . . . . . . . . . . 5mA
Internal Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . See Curves
Operating Ambient Temperature Range . . . . . . . . . .-40°C to +85°C
Operating Junction Temperature Plastic DIP or SOL. . . . . . . . 150°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA
Open-Loop DC Electrical Specifications
Provisional Supplies at ±15V, Load = 1kΩ; TA = +25°C
PARAMETER
DESCRIPTION
TEMP
MIN TYP
AMPLIFIER SECTION (HOLD = 5V)
VOS
Ib+
Input Offset Voltage
IN+ Input Bias Current
+25°C
12
+25°C
1
Ib-
IN- Input Bias Current
+25°C
18
ROL
RIN-
CMRR
Transimpedance (Note 1)
IN- Resistance
Common Mode Rejection Ratio (Note 2)
+25°C
+25°C
+25°C
180
800
20
44
60
VO
Output Voltage Swing
ISC
Short Circuit Current
(IN+ Only Driven to 0.5V)
+25°C
+25°C
±12
±13
45
100
RESTORE SECTION
VOS, Comp
Ib+, r
Composite Input Offset Voltage (Note 3)
Restore In+ Input Bias Current
+25°C
3
+25°C
3
IOUT
CMRR
Restoring Current Available
Common Mode Rejection Ratio (Note 2)
+25°C
+25°C
180
300
60
70
PSRR
Power Supply Rejection Ratio (Note 4)
+25°C
60
90
VTHRESHOLD
HOLD Logic Threshold
IIH, Hold
HOLD Input Current @ Logic High
IIL, Hold
HOLD Input Current @ Logic Low
SUPPLY CURRENT
+25°C
+25°C
+25°C
0.8
1
5
Isy, Hold
Supply Current (HOLD = 5V)
+25°C
4.8
6.0
Isy, Sampling
Supply Current (HOLD = 0V)
+25°C
5.0
6.5
MAX UNITS
25
mV
5
µA
150
µA
kΩ
Ω
dB
V
mA
7
mV
12
µA
µA
dB
dB
2.0
V
5
µA
15
µA
9.0
mA
11.0
mA
NOTES:
1. For current feedback amplifiers, AVOL = ROL/RIN-.
2. VCM = ±10V for VS = ±15V.
3. Measured from S/H Input to amplifier output, while restoring.
4. VOS is measured at VS = ±4.5V and VS = ±16V, both supplies are changed simultaneously.
2
Share Link: 