GM317LS8T データシートの表示（PDF） - Gamma Microelectronics Inc.
部品番号
コンポーネント説明
メーカー
GM317LS8T Datasheet PDF : 7 Pages
| |||
GM317L
3-TERMINAL 100mA
ADJUSTABLE REGULATOR
Application Information
Basic Circuit Operation
The GM317L is a 3- terminal floating regulator. In operation, tit develops and maintains a nominal 1.25V
reference (VREF) between its output and adjustment terminal. This reference voltage is converted to a
programming current flow through R2 to ground.
The regulated output voltage is given by:
VOUT
VIN
GM317L
Adjust
VREF
VOUT = VREF (1 +
R2
R1
)
+
IADJ
R2
IADJ
VREF = 1.25V typical
R1
IPROG
R2
Basic Circuit Configuration
Since the current from the adjustment terminal (IADJ) represents an error term in the equation, the GM317Lwas
designed to minimize IADJ and make it very constant with line and load changes. To do this, all quiescent
operating current is returned to the output establishing a minimum load current requirement. If there is
insufficient load on the output, the output will rise.
Since the GM317L is a floating regulator, it is only the voltage differential across the circuit which is important to
performance, and operation at high voltages with respect to ground is possible.
Load Regulation
The GM317L is capable of providing extremely good load regulation, but a few precautions are needed to obtain
maximum performance. For best performance, the programming resistor R1 should be connected as close to
the regulator as possible to minimize line drops which effectively appear in series with the reference, thereby
degrading regulation. The ground end of R2 can be returned near the load ground to provide remote ground
sensing and improve load regulation.
External Capacitors
A 0.1µF disc or 1.0µF tantalum input bypass capacitor CIN is recommended to reduce the sensitivity to input line
impedance. The adjustment terminal may be bypassed to ground to improve ripple rejection. This capacitor CADJ
prevents ripple from being amplified as the output voltage is increased. A 10µF capacitor should improve ripple
rejection about 15 dB at 120Hz in a 10V application.
Although the GM317L is stable with no output capacitance, like any feedback circuit, certain values of external
capacitance can cause excessive ringing. An output capacitance CO in the form of a 1.0µF tantalum or 25µF
aluminum electrolytic capacitor on the output swamps this effect and insures stability.
Protection Diodes
When external capacitors are used with any IC regulator, it is sometimes necessary to add protection diodes to
prevent the capacitors from discharging through low current points into the regulator.
The figure below shows the GM317L with the recommended protection diodes for output for output voltage in
excess of 25V or high capacitance values (CO > 25µF, CADJ > 10µF). Diode D1 prevents CO from discharging
thru the IC during an input short circuit. Diode D2 protects against capacitor CADJ discharging through the IC
during an output short circuit. The combination of diodes D1 and D2 prevents CADJ from discharging through the
IC during an input short circuit.
D1
1N4002
VOUT
VIN
GM317L
CIN
Adjust
R1
D2 CO
1N4002
R2
CADJ
5
Share Link: 