Philips Semiconductors
Dual universal serial communications controller (DUSCC)
Product specification
SCN26562
Character-Oriented Protocol Features
• Character length: 5 to 8 bits
• Odd or even parity, no parity, or force parity
• LRC or CRC generation and checking
• Optional opening PAD transmission
• One or two SYN characters
• External sync capability
• SYN detection and optional stripping
• SYN or MARK line-fill on underrun
• Idle in MARK or SYNs
• Parity, FCS, overrun, and underrun error detection
BISYNC Features
• EBCDIC or ASCII header, text and control messages
• SYN, DLE stripping
• EOM (end of message) detection and transmission
• Auto transparent mode switching
• Auto hunt after receipt of EOM sequence (with closing PAD check
after EOT or NAK)
• Control character sequence detection for both transparent and
normal text
ORDERING INFORMATION
DESCRIPTION
48-Pin Plastic Dual In-Line Package (DIP)
52-Pin Plastic Leaded Chip Carrier (PLCC) Package
Bit-Oriented Protocol Features
• Character length: 5 to 8 bits
• Detection and transmission of residual character: 0–7 bits
• Automatic switch to programmed character length for I field
• Zero insertion and detection
• Optional opening PAD transmission
• Detection and generation of FLAG, ABORT, and IDLE bit patterns
• Detection and generation of shared (single) FLAG between
frames
• Detection of overlapping (shared zero) FLAGs
• ABORT, ABORT-FLAGs, or FCS FLAGs line-fill on underrun
• Idle in MARK or FLAGs
• Secondary address recognition including group and global
address
• Single- or dual-octet secondary address
• Extended address and control fields
• Short frame rejection for receiver
• Detection and notification of received end of message
• CRC generation and checking
• SDLC loop mode capability
VCC = +5V +5%, TA = 0°C to +70°C
Serial Data Rate =
4Mbps Maximum
SCN26562C4N48
SCN26562C4A52
DWG #
SOT240-1
SOT238-3
ABSOLUTE MAXIMUM RATINGS1
SYMBOL
PARAMETER
RATING
UNIT
TA
Operating ambient temperature2
0 to +70
°C
TSTG
VCC
VS
Storage temperature
Voltage from VCC to GND3
Voltage from any pin to ground3
-65 to +150
°C
–0.5 to +7.0
V
–0.5 to VCC +0.5
V
NOTES:
1. Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and
functional operation of the device at these or any other conditions above those indicated in the operation section of this specification is not
implied.
2. For operating at elevated temperatures, the device must be derated based on +150°C maximum junction temperature and thermal
resistance of 36°C/W junction to ambient for ceramic DIP, 40°C/W for plastic DIP, and 42°C/W for PLCC.
3. This product includes circuitry specifically designed for the protection of its internal devices from damaging effects of excessive static
charge. Nonetheless, it is suggested that conventional precautions be taken to avoid applying any voltages larger than the rated maxima.
1995 May 1
2