LTC4001-1 データシートの表示（PDF） - Linear Technology
部品番号
コンポーネント説明
メーカー
LTC4001-1 Datasheet PDF : 20 Pages
| |||
APPLICATIONS INFORMATION
LTC4001-1
VINSENSE
9
RNOM
121k
NTC
11
LTC4001-1 NTC BLOCK
0.74 • VINSENSE –
+
TOO COLD
R1
13.3k
RNTC
100k
–
0.29 • VINSENSE +
TOO HOT
GNDSENS
4
+
0.02 • VINSENSE
–
NTC ENABLE
40011 F04
Figure 4. Extending the Delta Temperature
where RNOM is the value of the bias resistor, RHOT and
RCOLD are the values of RNTC at the desired temperature
trip points. Continuing the example from before with a
desired hot trip point of 50°C:
RNOM
=
RCOLD – RHOT
2.815 – 0.4086
=
100k • (3.2636 – 0.3602)
2.815 – 0.4086
= 120.8k, 121k is nearest 1%
R1=
100k
•
0.4086
2.815 – 0.4086
•
(3.266
–
0.3602)
–
0.3602
= 13.3k, 13.3k is nearest 1%
The final solution is as shown if Figure 4 where RNOM =
121k, R1 = 13.3k and RNTC = 100k at 25°C.
Input and Output Capacitors
The LTC4001-1 uses a synchronous buck regulator to
provide high battery charging current. A 10μF chip ceramic
capacitor is recommended for both the input and output
capacitors because it provides low ESR and ESL and can
handle the high RMS ripple currents. However, some
high Q capacitors may produce high transients due to
self-resonance under some start-up conditions, such as
connecting the charger input to a hot power source. For
more information, refer to Application Note 88.
EMI considerations usually make it desirable to minimize
ripple current in the battery leads, and beads or inductors
may be added to increase battery impedance at the 1.5MHz
switching frequency. Switching ripple current splits be-
tween the battery and the output capacitor depending on
the ESR of the output capacitor and the battery impedance.
If the ESR of the output capacitor is 0.1Ω and the battery
impedance is raised to 2Ω with a bead or inductor, only
5% of the ripple current will flow in the battery. Similar
techniques may also be applied to minimize EMI from
the input leads.
40011fa
13
Share Link: 