M25P16 データシートの表示（PDF） - Numonyx -> Micron

部品番号

コンポーネント説明

メーカー

M25P16

16 Mbit, serial Flash memory, 75 MHz SPI bus interface

Numonyx -> Micron 

M25P16

DC and AC parameters

Table 15. AC characteristics (grade 6, T9HX technology) (continued)

Applies only to products made with T9HX technology, identified with process digit ‘4’(1)

Test conditions specified in Table 10 and Table 12

Symbol Alt.

Parameter

Min

Typ(2)

Max Unit

Page Program cycle time (256 bytes)

0.64

tPP (7)

Page Program cycle time (n bytes, where n = 1

to 4)

Page Program cycle time (n bytes, where n = 5

to 256)

0.01

5 ms

int(n/8) × 0.02(8)

tSE

Sector Erase cycle time

tBE

Bulk Erase cycle time

0.6

3s

13

40 s

1. Details of how to find the technology process in the marking are given in AN1995, see also Section 12:

Part numbering.

2. Typical values given for TA = 25 °C.

3. tCH + tCL must be greater than or equal to 1/ fC.

4. Value guaranteed by characterization, not 100% tested in production.

5. Expressed as a slew-rate.

6. Only applicable as a constraint for a WRSR instruction when SRWD is set at ‘1’.

7. When using the Page Program (PP) instruction to program consecutive bytes, optimized timings are

obtained with one sequence including all the bytes versus several sequences of only a few bytes (1 ≤n ≤

256).

8. int(A) corresponds to the upper integer part of A. For instance, int(12/8) = 2, int(32/8) = 4, int(15.3) =16.

41/55

Share Link: