M25P40-VMN6GX データシートの表示（PDF） - Numonyx -> Micron

部品番号

コンポーネント説明

メーカー

M25P40-VMN6GX

4 Mbit, low voltage, serial Flash memory with 75 MHz SPI bus interface

Numonyx -> Micron 

M25P40

Instructions

6.3

Read Identification (RDID)

The Read Identification (RDID) instruction allows to read the device identification data:

„ Manufacturer identification (1 byte)

„ Device identification (2 bytes)

A Unique ID code (UID) (17 bytes, of which 16 available upon customer request).(2)

The manufacturer identification is assigned by JEDEC, and has the value 20h for Numonyx.

The device identification is assigned by the device manufacturer, and indicates the memory

type in the first byte (20h), and the memory capacity of the device in the second byte (13h).

The UID contains the length of the following data in the first byte (set to 10h), and 16 bytes

of the optional Customized Factory Data (CFD) content. The CFD bytes are read-only and

can be programmed with customers data upon their demand. If the customers do not make

requests, the devices are shipped with all the CFD bytes programmed to zero (00h). Any

Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is not

decoded, and has no effect on the cycle that is in progress. The device is first selected by

driving Chip Select (S) Low. Then, the 8-bit instruction code for the instruction is shifted in.

After this, the 24-bit device identification, stored in the memory, the 8-bit CFD length

followed by 16 bytes of CFD content will be shifted out on Serial Data output (Q). Each bit is

shifted out during the falling edge of Serial Clock (C).

The instruction sequence is shown in Figure 9.

The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at

any time during data output.

When Chip Select (S) is driven High, the device is put in the Stand-by Power mode. Once in

the Stand-by Power mode, the device waits to be selected, so that it can receive, decode

and execute instructions.

Table 5. Read Identification (RDID) data-out sequence

Manufacturer identification

Device identification

Memory type

Memory capacity

UID

CFD length CFD content

20h

20h

13h

10h

16 bytes

2. The UID feature is available only for process technology T9HX devices, identified by with process identification

digit "4" in the device marking and process letter "B" in the part number.

21/57

Share Link: