M29W160DB データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

M29W160DB

16 Mbit (2Mb x8 or 1Mb x16, Boot Block) 3V Supply Flash Memory

STMicroelectronics 

M29W160DT, M29W160DB

Erase Timer Bit (DQ3). The Erase Timer Bit can

be used to identify the start of Program/Erase

Controller operation during a Block Erase com-

mand. Once the Program/Erase Controller starts

erasing the Erase Timer Bit is set to ’1’. Before the

Program/Erase Controller starts the Erase Timer

Bit is set to ’0’ and additional blocks to be erased

may be written to the Command Interface. The

Erase Timer Bit is output on DQ3 when the Status

Register is read.

Alternative Toggle Bit (DQ2). The Alternative

Toggle Bit can be used to monitor the Program/

Erase controller during Erase operations. The Al-

ternative Toggle Bit is output on DQ2 when the

Status Register is read.

During Chip Erase and Block Erase operations the

Toggle Bit changes from ’0’ to ’1’ to ’0’, etc., with

successive Bus Read operations from addresses

within the blocks being erased. Once the operation

completes the memory returns to Read mode.

During Erase Suspend the Alternative Toggle Bit

changes from ’0’ to ’1’ to ’0’, etc. with successive

Bus Read operations from addresses within the

blocks being erased. Bus Read operations to ad-

dresses within blocks not being erased will output

the memory cell data as if in Read mode.

After an Erase operation that causes the Error Bit

to be set the Alternative Toggle Bit can be used to

identify which block or blocks have caused the er-

ror. The Alternative Toggle Bit changes from ’0’ to

’1’ to ’0’, etc. with successive Bus Read Opera-

tions from addresses within blocks that have not

erased correctly. The Alternative Toggle Bit does

not change if the addressed block has erased cor-

rectly.

Table 10. Status Register Bits

Operation

Address

DQ7

DQ6

DQ5

DQ3

DQ2

RB

Program

Any Address

DQ7

Toggle

0

–

–

0

Program During Erase

Suspend

Any Address

DQ7

Toggle

0

–

–

0

Program Error

Any Address

DQ7

Toggle

1

–

–

0

Chip Erase

Any Address

0

Toggle

0

1

Toggle

0

Block Erase before

timeout

Erasing Block

0

Toggle

0

Non-Erasing Block

0

Toggle

0

0

Toggle

0

0

No Toggle

0

Block Erase

Erasing Block

0

Toggle

0

Non-Erasing Block

0

Toggle

0

1

Toggle

0

1

No Toggle

0

Erase Suspend

Erasing Block

1

No Toggle

0

–

Toggle

1

Non-Erasing Block

Data read as normal

1

Erase Error

Good Block Address

0

Toggle

1

Faulty Block Address

0

Toggle

1

Note: Unspecified data bits should be ignored.

1

No Toggle

0

1

Toggle

0

17/29

Share Link: