M41T83 データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

M41T83

Serial RTC with battery switchover

STMicroelectronics 

M41T82 M41T83

Operation

2.1

2.1.1

2.1.2

2.1.3

2.1.4

2-Wire bus characteristics

The bus is intended for communication between different ICs. It consists of two lines: a bi-

directional data signal (SDA) and a clock signal (SCL). Both the SDA and SCL lines must be

connected to a positive supply voltage via a pull-up resistor.

The following protocol has been defined:

● Data transfer may be initiated only when the bus is not busy.

● During data transfer, the data line must remain stable whenever the clock line is High.

● Changes in the data line, while the clock line is High, will be interpreted as control

signals.

Accordingly, the following bus conditions have been defined:

Bus not busy

Both data and clock lines remain High.

Start data transfer

A change in the state of the data line, from high to Low, while the clock is High, defines the

START condition.

Stop data transfer

A change in the state of the data line, from Low to High, while the clock is High, defines the

STOP condition.

Data valid

The state of the data line represents valid data when after a start condition, the data line is

stable for the duration of the high period of the clock signal. The data on the line may be

changed during the Low period of the clock signal. There is one clock pulse per bit of data.

Each data transfer is initiated with a start condition and terminated with a stop condition.

The number of data bytes transferred between the start and stop conditions is not limited.

The information is transmitted byte-wide and each receiver acknowledges with a ninth bit.

By definition a device that gives out a message is called “transmitter,” the receiving device

that gets the message is called “receiver.” The device that controls the message is called

“master.” The devices that are controlled by the master are called “slaves.”

15/58

Share Link: