HL15203
11. Power Down Mode
Sleep mode is set up by setting S0 or S1 in the control data to 1. The segment
outputs will all go low and the common outputs will also go low, and the oscillator
on the OSC pin will stop ( it will be started by a key press). This reduces power
dissipation. This mode is cleared by sending control data with both S0 and S1 set
to 0. Note that the SEG1 to SEG4 outputs can be used as general purpose output
ports according to the state of the P0 and P1 control data bits, even in sleep
mode.
13
Preliminary