M95080 データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

M95080

16Kbit and 8Kbit Serial SPI Bus EEPROM With High Speed Clock

STMicroelectronics 

M95160, M95080

Read from Memory Array (READ)

As shown in Figure 11., to send this instruction to

the device, Chip Select (S) is first driven Low. The

bits of the instruction byte and address bytes are

then shifted in, on Serial Data Input (D). The ad-

dress is loaded into an internal address register,

and the byte of data at that address is shifted out,

on Serial Data Output (Q).

If Chip Select (S) continues to be driven Low, the

internal address register is automatically incre-

mented, and the byte of data at the new address is

shifted out.

When the highest address is reached, the address

counter rolls over to zero, allowing the Read cycle

to be continued indefinitely. The whole memory

can, therefore, be read with a single READ instruc-

tion.

The Read cycle is terminated by driving Chip Se-

lect (S) High. The rising edge of the Chip Select

(S) signal can occur at any time during the cycle.

The first byte addressed can be any byte within

any page.

The instruction is not accepted, and is not execut-

ed, if a Write cycle is currently in progress.

Figure 11. Read from Memory Array (READ) Sequence

S

0 1 2 3 4 5 6 7 8 9 10 20 21 22 23 24 25 26 27 28 29 30 31

C

Instruction

16-Bit Address

D

15 14 13 3 2 1 0

MSB

High Impedance

Q

Data Out 1

Data Out 2

76543 2107

MSB

AI01793D

Note: Depending on the memory size, as shown in Table 7., the most significant address bits are Don’t Care.

17/40

Share Link: