MACH211SP-10 データシートの表示（PDF） - Advanced Micro Devices
部品番号
コンポーネント説明
メーカー
MACH211SP-10 Datasheet PDF : 37 Pages
| |||
SWITCHING CHARACTERISTICS over COMMERCIAL operating ranges (Note 2)
(continued)
Parameter
Symbol
Parameter Description
-7
Min Max
-10
Min Max Unit
tIGS
Input Latch Gate to Output Latch Setup
10
11
ns
tWIGL Input Latch Gate Width LOW
3
5
ns
tPDLL
Input, I/O, or Feedback to Output Through Transparent Input and
Output Latches
12.5
14
ns
tAR
Asynchronous Reset to Registered or Latched Output
9.5
15
ns
tARW Asynchronous Reset Width (Note 1)
5
10
ns
tARR Asynchronous Reset Recovery Time (Note 1)
5
10
ns
tAP
Asynchronous Preset to Registered or Latched Output
9.5
15
ns
tAPW Asynchronous Preset Width (Note 1)
5
10
ns
tAPR Asynchronous Preset Recovery Time (Note 1)
5
10
ns
tEA
Input, I/O, or Feedback to Output Enable (Note 1)
9.5
12
ns
tER
Input, I/O, or Feedback to Output Disable (Note 1)
9.5
12
ns
tLP
tPD Increase for Powered-down Macrocell (Note 3)
10
10
ns
tLPS
tS Increase for Powered-down Macrocell (Note 3)
10
10
ns
tLPCO tCO Increase for Powered-down Macrocell (Note 3)
0
0
ns
tLPEA tEA Increase for Powered-down Macrocell (Note 3)
10
10
ns
Notes:
1. These parameters are not 100% tested, but are evaluated at initial characterization and at any time the design is modified
where frequency may be affected.
2. See Switching Test Circuit for test conditions.
3. If a signal is powered-down, this parameter must be added to its respective high-speed parameter.
12
MACH211SP-7/10 (Com’l)
Share Link: 