P89LPC932FDH データシートの表示（PDF） - Philips Electronics

部品番号

コンポーネント説明

メーカー

P89LPC932FDH

8-bit microcontroller with accelerated two-clock 80C51 core 8 kB Flash with 512-byte data EEPROM and 768-byte RAM

Philips Electronics 

Philips Semiconductors

P89LPC932

8-bit microcontroller with accelerated two-clock 80C51 core

9397 750 12379

Product data

8.6 CPU Clock (CCLK) wake-up delay

The P89LPC932 has an internal wake-up timer that delays the clock until it stabilizes

depending on the clock source used. If the clock source is any of the three crystal

selections (low, medium and high frequencies) the delay is 992 OSCCLK cycles plus

60 to 100 µs. If the clock source is either the internal RC oscillator, watchdog

oscillator, or external clock, the delay is 224 OSCCLK cycles plus 60 to 100 µs.

8.7 CPU Clock (CCLK) modification: DIVM register

The OSCCLK frequency can be divided down up to 510 times by configuring a

dividing register, DIVM, to generate CCLK. This feature makes it possible to

temporarily run the CPU at a lower rate, reducing power consumption. By dividing the

clock, the CPU can retain the ability to respond to events that would not exit Idle

mode by executing its normal program at a lower rate. This can also allow bypassing

the oscillator start-up time in cases where Power-down mode would otherwise be

used. The value of DIVM may be changed by the program at any time without

interrupting code execution.

8.8 Low power select

The P89LPC932 is designed to run at 12 MHz (CCLK) maximum. However, if CCLK

is 8 MHz or slower, the CLKLP SFR bit (AUXR1.7) can be set to ‘1’ to lower the power

consumption further. On any reset, CLKLP is ‘0’ allowing highest performance

access. This bit can then be set in software if CCLK is running at 8 MHz or slower.

8.9 Memory organization

The various P89LPC932 memory spaces are as follows:

• DATA

128 bytes of internal data memory space (00h:7Fh) accessed via direct or indirect

addressing, using instructions other than MOVX and MOVC. All or part of the

Stack may be in this area.

• IDATA

Indirect Data. 256 bytes of internal data memory space (00h:FFh) accessed via

indirect addressing using instructions other than MOVX and MOVC. All or part of

the Stack may be in this area. This area includes the DATA area and the 128 bytes

immediately above it.

• SFR

Special Function Registers. Selected CPU registers and peripheral control and

status registers, accessible only via direct addressing.

• XDATA

‘External’ Data or Auxiliary RAM. Duplicates the classic 80C51 64 kB memory

space addressed via the MOVX instruction using the SPTR, R0, or R1. All or part

of this space could be implemented on-chip. The P89LPC932 has 512 bytes of

on-chip XDATA memory.

• CODE

64 kB of Code memory space, accessed as part of program execution and via the

MOVC instruction. The P89LPC932 has 8 kB of on-chip Code memory.

Rev. 04 — 06 January 2004

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

19 of 60

Share Link: