PSD813F1V-12JIT データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

PSD813F1V-12JIT

Flash In-System Programmable (ISP) Peripherals for 8-bit MCUs, 3.3V

STMicroelectronics 

PSD813F1V

DETAILED OPERATION

As shown in Figure 5., page 13, the PSD consists

of six major types of functional blocks:

■ Memory Blocks

■ PLD Blocks

■ MCU Bus Interface

■ I/O Ports

■ Power Management Unit (PMU)

■ JTAG Interface

The functions of each block are described in the

following sections. Many of the blocks perform

multiple functions, and are user configurable.

MEMORY BLOCKS

The PSD has the following memory blocks (see

Table 7):

– The Main Flash memory

– Secondary EEPROM memory

– SRAM

The Memory Select signals for these blocks origi-

nate from the Decode PLD (DPLD) and are user-

defined in PSDsoft Express.

Primary Flash Memory and Secondary

EEPROM Description

The 1Mb primary Flash memory is divided evenly

into eight 16-KByte sectors. The EEPROM memo-

ry is divided into four sectors of eight KBytes each.

Each sector of either memory can be separately

protected from Program and Erase operations.

Flash memory may be erased on a sector-by-sec-

tor basis and programmed byte-by-byte. Flash

sector erasure may be suspended while data is

read from other sectors of memory and then re-

sumed after reading.

EEPROM may be programmed byte-by-byte or

sector-by-sector, and erasing is automatic and

transparent. The integrity of the data can be se-

cured with the help of Software Data Protection

(SDP). Any write operation to the EEPROM is in-

hibited during the first five milliseconds following

power-up.

During a program or erase of Flash, or during a

write of the EEPROM, the status can be output on

the Ready/Busy (PC3) pin of Port C3. This pin is

set up using PSDsoft Express Configuration.

Memory Block Select Signals. The decode

PLD in the PSD generates the chip selects for all

the internal memory blocks (refer to the section

entitled PLD’S, page 34). Each of the eight Flash

memory sectors have a Flash Select signal (FS0-

FS7) which can contain up to three product terms.

Each of the four EEPROM memory sectors have a

Select signal (EES0-3 or CSBOOT0-3) which can

contain up to three product terms. Having three

product terms for each sector select signal allows

a given sector to be mapped in different areas of

system memory. When using a microcontroller

with separate Program and Data space, these

flexible select signals allow dynamic re-mapping of

sectors from one space to the other.

Ready/Busy Pin (PC3). Pin PC3 can be used to

output the Ready/Busy status of the PSD. The out-

put on the pin will be a ‘0’ (Busy) when Flash or

EEPROM memory blocks are being written to, or

when the Flash memory block is being erased.

The output will be a ‘1’ (Ready) when no write or

erase operation is in progress.

Table 7. Memory Blocks

Device

Main Flash

PSD813F1

128KB

EEPROM

32KB

SRAM

2KB

18/110

Share Link: