RT9203A データシートの表示（PDF） - Richtek Technology
部品番号
コンポーネント説明
メーカー
RT9203A Datasheet PDF : 16 Pages
| |||
Preliminary
A multi-layer printed circuit board is recommended. Figure
13 shows the connections of the critical components in
the converter. Note that the capacitors CIN and COUT
represent numerous physical capacitors. Use a dedicated
grounding plane and use vias to ground all critical
components to this layer. Apply another solid layer as a
power plane and cut this plane into smaller islands of
common voltage levels. The power plane should support
the input power and output power nodes. Use copper filled
polygons on the top and bottom circuit layers for the
PHASE node, but it is not necessary to oversize this
particular island. Since the PHASE node is subjected to
very high dV/dt voltages, the stray capacitance formed
between these islands and the surrounding circuitry will
tend to couple switching noise. Use the remaining printed
circuit layers for small signal routing. The PCB traces
between the PWM controller and the gate of MOSFET
and also the traces connecting source of MOSFETs
should be sized to carry 2A peak currents.
5V
GND
IQ1
IL
Q1
IQ2
Q2
VOUT
LOAD
LGATE VCC GND
UGATE
RT9203/A
FB
Figure 13
RT9203/A
DS9203/A-10 March 2007
www.richtek.com
15
Share Link: 