80296SA データシートの表示（PDF） - Intel

部品番号

コンポーネント説明

メーカー

80296SA

COMMERCIAL CHMOS 16-BIT MICROCONTROLLER

Intel 

80296SA COMMERCIAL CHMOS 16-BIT MICROCONTROLLER

Table 6. DC Characteristics Over Specified Operating Conditions (Continued)

Symbol

Parameter

Min

Typical

(Note 1)

Max

Units

Test

Conditions

IPD

Powerdown Mode Current

20

50

µA VCC = 5.5 V

(Note 2)

ISTDBY

ILI

Standby Mode

Input Leakage Current

(Standard Inputs)

8

15

mA VCC = 5.5 V

±10

µA VSS < VIN < VCC

VIL

Input Low Voltage (all pins)

–0.5

VIL1

Input Low Voltage XTAL1

–0.5

VIH

Input High Voltage

0.2 VCC +1

VIH1

Input High Voltage XTAL1

0.7 VCC

VOL

Output Low Voltage (output

configured as complementary)

(Note 3, 4)

VOL1

Output Low Voltage on P4.3:0

(output configured as comple-

mentary) (Note 4)

0.8

V

0.3 VCC

V

VCC + 0.5 V

VCC + 0.5 V

0.3

0.45

1.5

V IOL = 200 µA

V IOL = 3.2 mA

V IOL = 7.0 mA

0.45

0.6

V IOL = 8 mA

V IOL = 15 mA

VOL2

Output Low Voltage in Reset

on ALE, INST, and NMI

0.45

V IOL = 3 µA

VOL3

Output Low Voltage in Reset

on ONCE pin

0.45

V IOL = 30 µA

VOL4

Output Low Voltage on XTAL2

VOH

VOH1

Output High Voltage (output

configured as complementary)

(Note 4)

Output High Voltage in Reset

(Note 5)

VCC – 0.5

VCC – 0.9

VCC – 1.5

VCC – 0.7

0.3

0.45

1.5

V IOL = 100 µA

V IOL = 700 µA

V IOL = 3 mA

V IOH = –200 µA

V IOH = –3.2 mA

V IOH = –7.0 mA

V IOH = –3 µA

NOTES:

1. Typical values are based on a limited number of samples and are not guaranteed. The values listed

are at room temperature with VCC = 5.0 V.

2. For temperatures below 100°C, typical is 10 µA.

3. For all pins except P4.3:0, which have higher drive capability (see VOL1).

4. During normal (non-transient) conditions, the following maximum current limits apply for pin groups

and individual pins:

Group

P1.7:3, P4

P2

P1.2:0, P3

IOL (mA)

40

40

40

IOH (mA)

40

40

40

Individual

P1, P2, P3

P4

IOL (mA)

10

18

IOH (mA)

10

10

5. For all pins that were weakly pulled high during reset. This excludes ALE, INST, and NMI, which were

weakly pulled low (see VOL2) and ONCE, which was pulled medium low (see VOL3).

6. Pin capacitance is not tested. This value is based on design simulations.

PRELIMINARY

15

Share Link: