DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

UBA2025T データシートの表示(PDF) - NXP Semiconductors.

部品番号
コンポーネント説明
メーカー
UBA2025T
NXP
NXP Semiconductors. NXP
UBA2025T Datasheet PDF : 17 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
NXP Semiconductors
UBA2025
CFL power IC
Table 3. Minimum gate voltages
Frequency
< 75 kHz
75 kHz to 80 kHz
> 85 kHz
Voltage
8 V (min.)
7 V (min.)
6 V (min.)
The drive voltage at gate of T2 (G2) will exceed the drive voltage of the high side driver.
7.12 Frequency and change in frequency
At any point in time during oscillation, the circuit will operate between fbtm and fstart. Any
change in frequency will be gradual, no steps in frequency will occur. Changes in
frequency caused by a change in voltage at pin CI, show a rather constant df/dt over the
entire frequency range. The following rates are realised (at a frequency of 85 kHz and a
100 nF connected to pin CI):
For any increase in frequency the df/dt will be between 15 kHz/ms and 37.5 kHz/ms
During preheat and normal operation: the df/dt for a decrease in frequency is between
6 kHz/ms and 15 kHz/ms
During the ignition phase: the df/dt for a decrease in frequency is between
150 Hz/msand 375 Hz/ms.
7.13 Ground pins
Pin PGND and pin GND are the ground references of the IC with respect to the
application. Pin SGND provides a local ground reference for the components connected
to pins CPAV, CI, IREF and CF. Other external connections to pin SGND are not preferred.
The sum of currents flowing out of the pins CPAV, CI, IREF, CF and SGND must remain
zero at any time. Pin GND is internally connected to SGND.
7.14 Charge coupling
Due to parasitic capacitive coupling to the high voltage circuitry, all pins are exposed to a
repetitive charge injection. Given the typical application in figure 6, the pins IREF and CF
are sensitive to this charge injection. For the rating Qcoup a safe functional operation of the
IC is guaranteed, independent of the current level. Charge coupling at current levels below
50 µA will not interfere with the accuracy of the Vth(capm) and Vshunt levels. Charge coupling
at current levels below 20 µA will not interfere with the accuracy of any parameter.
UBA2025_1
Product data sheet
Rev. 01 — 16 October 2009
© NXP B.V. 2009. All rights reserved.
7 of 17

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]