CL1F1103 データシートの表示（PDF） - Unspecified

部品番号

コンポーネント説明

メーカー

CL1F1103

Clipper Industrial Plastic Connectors

Unspecified 

Clipper Industrial Plastic Connectors

Manual Crimping Tool

Stamped and Formed Contacts

(#16 and #20)

• Squeeze the plier handles until a final click sounds, release, the pliers should

open by themselves.

• Fully insert the contact into the locator (corresponding gauge), the contact

crimping lugs should be directed upwards, according to the drawing.

• Put the stripped wire in the crimping part until it comes in contact with the

stopper plate. Make sure that no strands stick out of the crimping part.

• Squeeze the plier handles until a final click sounds, release, the pliers should

open by themselves.

• Check the overall aspect of the crimping.

Y16SCMCL3

Machined Crimping Contacts

(#16 and #20)

8365

with

locator

8365-02

• Push the cable into the contact barrel and make sure the cable strands stick out

of the inspection hole.

• The pliers must be used on the jaws side.

• Squeeze the plier handles until a final click sounds, release, the pliers should

open by themselves.

• Insert both wire and contact (or wire, reducing sleeve and contact) between the

4 jaws until stopped by the locator.

• Fully squeeze until a final click sounds, the pliers should open once the crimping

is performed

• Extract the wire and crimped contact, then check the overall aspect of the

crimping.

18

Share Link: