AT42QT1110-MU(2010) データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT42QT1110-MU
(Rev.:2010)

QTouch™ 11-key Sensor IC

Atmel Corporation 

AT42QT1110-MU/AT42QT1110-AU

4.1.5.2

Get Instructions

Get instructions are instructions that read the data from a location in the QT1110 memory map.

Figure 4-7. Positive Recalibration Delay Get Instruction – CRC Disabled

Host (Sends on MOSI)

Device (Responds on MISO)

Command: 0xD5

Response: 0x55 (“Idle” – Fresh Command)

Simultaneous

Transmission

Null: 0x00

“Get” Data: 0x0C (Positive Recalibration Delay)

The host sends the appropriate “Get” command, followed by a “Null” byte. The QT1110 returns

the contents of the addressed memory location.

Figure 4-7 on page 15 shows the exchange for a report on the positive recalibration delay

(assuming that the data byte is 0x0C).

With CRC Enabled, this exchange takes 4 bytes, with a command CRC transmitted by the host

and a report CRC returned by the QT1110 (see Figure 4-8).

Figure 4-8. Positive Recalibration Delay Get Instruction – CRC Enabled

Host (Sends on MOSI)

Device (Responds on MISO)

Command: 0xD5

Response: 0x55 (“Idle” – Fresh Command)

Simultaneous

Transmission

Command CRC: 0x68

Response: 0x68 (Expected Command CRC)

Null: 0x00

“Get” Data: 0x0C (Positive Recalibration Delay)

Null: 0x00

“Get” CRC: 0xA3

15

9520I–AT42–03/10

Share Link: