VNI4140K-32
Quad high-side smart power solid-state relay
Datasheet - production data
PowerSSO-24
• Fast demagnetization of inductive loads
• Conforms to IEC 61131-2
• ESD according to IEC 61000-4-2 up to +/-
25 KV
Features
Type
VNI4140K-32
1. Per channel
Vdemag(1) RDS(on)(1) Iout(1) VCC
VCC-41 V 0.08 Ω 1 A 41 V
• Output current: 1 A per channel
• Shorted load protections
• Junction overtemperature protection
• Case overtemperature protection for thermal
independence of the channels
• Thermal case shutdown restart not
simultaneous for the various channels
• Protection against loss of ground
• Current limitation
• Undervoltage shutdown
• Open drain diagnostic outputs
• 3.3 V CMOS/TTL compatible inputs
Description
The VNI4140K-32 is a monolithic device made
using STMicroelectronics VIPower technology,
intended to drive four independent resistive,
capacitive or inductive loads with one side
connected to ground. Active current limitation
avoids the system power supply dropping in case
of shorted load. Built-in thermal shutdown
protects the chip from overtemperature and short-
circuit. In overload conditions, the channel turns
OFF and back ON automatically so to maintain
junction temperature between TTSD and TR. If this
condition causes case temperature to reach
TCSD, the overloaded channel is turned OFF and
restarts only when case temperature has
decreased down to TCR. In case of more than one
channel in overload, restart of the overloaded
channels is not simultaneous, in order to avoid
high peak current from the supply. Non-
overloaded channels continue operating normally.
The open drain diagnostic outputs indicate
overtemperature conditions.
Figure 1. Block diagram
December 2013
This is information on a product in full production.
DocID022576 Rev 6
1/28
www.st.com
28