UBA20262 データシートの表示（PDF） - NXP Semiconductors.
部品番号
コンポーネント説明
メーカー
UBA20262 Datasheet PDF : 32 Pages
| |||
NXP Semiconductors
UBA20261/2
600 V and 350 V power IC for step dimmable CFLs
voltage
(V)
5V
Vth(CP)max 4.5 V
Vth(CP)min 3.8 V
Vth(CB)max 3.6 V
VCB
VCP 1
32
Vth(CB)min 1.1 V
0.6 V
0V
ignition
1
2
61
62
63
boost
transition
burn
time (s)
001aam765
Fig 6. Boost timing
In the boost state, a lamp current feedback control is implemented to improve lamp
stability (see Section 7.1.6). The lamp current has a fixed ratio of 1.5 compared to the
burn state to boost the slow luminescence increase of a cold CFL lamp. In the boost to
burn transition time, there is a slow 15-step ratio decrease from 1.5 down to 1. The
preheat timer is reused for the transition to burn time and the boost ratio is gradually
decreased in 15 steps from 1.5 to 1, within 32 saw-tooth pulses on the CP pin. Using the
application values for CCB and Rext(RREF), a boost time of more than 300 s is possible. In
addition to boost bypass at a temperature of Tj(bp)bst ( 80 C), a temperature protection
function is implemented during boost state of Tj(end)bst ( 120 C). If the temperature
passes this level during boost, the transition timer is immediately started to enter the burn
state faster. Effectively this reduces the boost time (see Figure 4 [B]).
The boost state current boost does not start in dim modes DIM_2, DIM_3 or MDL
(see Figure 4 [A]).
Remark: If the CB pin is short circuited to ground, the boost function is disabled. In such a
situation, the bottom frequency fbridge(min) is 1.8 times higher than the boost bottom
frequency fbridge(bst)min.
7.1.6 Burn state
After the boost state or when it is bypassed, the burn state starts. The lamp current sensor
circuit remains enabled (see Figure 4[A]). The voltage across sense resistor RCSI, is
measured by the CSI (Current Sense Input) pin. It is then passed through a Double-Sided
Rectifier (DSR) circuit and fed towards an Operational Transconductor Amplifier (OTA).
When the RMS voltage on the CSI pin reaches the actual internal reference level, the
lamp current sensor circuit takes over control of the lamp current. The internal current
output of the OTA is transferred using an integrator on the CI pin to the input for Voltage
Controlled Oscillator (VCO). The VCO regulates the frequency and as a result, the lamp
current.
UBA20261_UBA20262
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 10 October 2011
© NXP B.V. 2011. All rights reserved.
9 of 32
Share Link: 