BD2802GU
Technical Note
●When two BD2802GU drivers are used and the clock is shared by CLKIO:
Because a sequence is already programmed within an IC chip for RGB falling, “Enable” shall be set to “OFF” and
clock supply shall be continued for at least three clocks so that operations can be performed using external clocks.
マスMタaーste側r eEnanbalbelde
スレSーlaブve側enEabnlaebdle
(min=0ms)
Master: Chip using CLKIO as output
Slave: Chip using CLKIO as input
mmini=nス= レslaーveブin側pu入t c力locクk ロ(3ッcloクckのs) 3 クロック分
(マ(Fスorタmーas側terのclクocロksッinクusをe:使m用in し= 1て5 いsる) 場合は min=15μs)
*Even in independent slave mode, its setting “Enable” shall be reset to “OFF” and then clock supply must be
continued for 3 clocks or more.
Clock I/O switching shall be avoided during RGB operation.
Enable: CLKEN, RGB1EN, RGB2EN, RGB1OS, RGB2OS
- Setting example
Master side (clock output side)
RGB waveform setting
Slave side (clock input side)
RGB waveform setting
Master side Clock output setting
CLKEN=1, CLKMD=1
… Performs clock output.
Slave side Clock input setting
CLKEN=1, CLKMD=0
… Allows clock reception.
Master side RGB lighting
This duration shall be short as much as possible.
Slave side RGB lighting
www.rohm.com
© 2011 ROHM Co., Ltd. All rights reserved.
20/27
2011.04 - Rev.A