TDA7719TR データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

TDA7719TR

3 band car audio processor

STMicroelectronics 

TDA7719

Description

4.11

DC offset detector and level meter option

This device provide DC offset detector function and level meter function option. In one

specific application, only one of the function can be used. The configuration of the function

is controlled by I2C bus (Byte3 Bit7).

When the device uses DC offset detector function, Pin22, Pin27 and Pin28 are used as

WinTC, DCErr and WinIN for DC offset detector. When it is configured as level meter, DCErr

becomes level meter output. In the mean time, WinIN is used as beep input (Mono single-

ended input for mixing), and WinTC becomes a reference voltage output (4 V external DC

voltage or 3.3 V internal reference voltage).

4.12

DC offset detector

Using the DC offset detection circuit (Figure 19) an offset voltage difference between the

audio power amplifier and the TDA7719's Front and Rear outputs can be detected,

preventing serious damage to the loudspeakers. The circuit compares whether the signal

crosses the zero level inside the audio power at the same time as in the speaker cell. The

output of the zero-window-comparator of the power amplifier must be connected with the

WinIn-input of the TDA7719. The WinIn-input has an internal pull-up resistor connected to

5.5Volts. It is recommended to drive this pin with open-collector outputs only.

To compensate for errors at low frequencies the WinTC-pin are implemented, with external

capacitors introducing the same delay  = 7.5k * Cext as the AC-coupling between the

TDA7719 and the power amplifier introduces. For the zero window comparators, the time

constant for spike rejection as well as the threshold are programmable.

For electrical characteristics see Chapter 3 on page 9.

A low-active DC-offset error signal appears at the DCErr output if the next conditions are

both true:

a) Front and rear outputs are inside zero crossing windows.

b) The Input voltage VWinIn is logic low whenever at least one output of the power

amplifier is outside the zero crossing windows.

After power-on, the external attached capacitor is rapidly charged (fast-charge) to overcome

a false indication.

Doc ID 13698 Rev 5

25/46

Share Link: