ATSGA204A データシートの表示（PDF） - Microchip Technology
部品番号
コンポーネント説明
メーカー
ATSGA204A Datasheet PDF : 93 Pages
| |||
ATSHA204A
Device Organization
Name
Bit Length Description
The source of the randomness in TempKey:
SourceFlag
1
0 = Internally generated random number (Rand).
1 = Input seed only, no internal random generation (Input).
GenData
0 = TempKey.SlotID is not meaningful and is ignored.
1
1
=
The contents of TempKey were generated by GenDig using one of the slots in the
Data zone (and TempKey.SlotID is meaningful).
0=
TempKey contents have been generated using a Nonce, SHA or GenDig without a
CheckMac key restriction.
CheckFlag
1
The contents of TempKey were generated by the GenDig command and at least
1 = one of the keys used in that generation is restricted to the CheckMac command
(SlotConfig.CheckOnly is one)
Valid
0=
The information in TempKey is invalid.
1
1=
The information in TempKey is valid.
In this specification, the name “TempKey” refers to the contents of the 32-byte (256-bit) Data register. The
remaining bit fields are referred to as TempKey.SourceFlag, TempKey.GenData and so on.
The TempKey.Valid bit is cleared to zero under any of the following circumstances:
• Power-up, sleep, brown-out, watchdog expiration, or tamper detection. The contents of TempKey
are however retained when the device enters idle mode.
• After the execution of any command other than Nonce or GenDig, regardless of whether or not the
command execution succeeds. It may be cleared by the CheckMac command unless a successful
copy takes place. It is not cleared if there is a communications problem, as evidenced by a Cyclic
Redundancy Check (CRC) error.
• An error during the parsing or execution of a GenDig and/or Nonce command.
• Execution of GenDig replaces any previous output of the Nonce command with the output of the
GenDig command. Execution of the Nonce command likewise replaces any previous output of the
GenDig command.
© 2018 Microchip Technology Inc.
DS40002025A-page 18
Share Link: 