HD44780U データシートの表示（PDF） - Hitachi -> Renesas Electronics

部品番号

コンポーネント説明

メーカー

HD44780U

Low-Power Dot-Matrix Liquid Crystal Display Controller/Driver with Key Scan Function

Hitachi -> Renesas Electronics 

HD66727

Instructions

Outline

Only the instruction register (IR) and the data register (DR) of the HD66727 can be controlled by the MPU.

Before starting internal operation of the HD66727, control information is temporarily stored in these

registers to allow interfacing with various peripheral control devices or MPUs which operate at different

speeds. The internal operation of the HD66727 is determined by signals sent from the MPU. These signals,

which include register selection bit (RS), read/write bit (R/W), and the data bus (DB0 to DB7), make up the

HD66727 instructions. There are four categories of instructions that:

• Control display

• Control key scan

• Control power management

• Set internal RAM addresses

• Perform data transfer with internal RAM

Normally, instructions that perform data transfer with internal RAM are used the most. However, auto-

incrementation by 1 (or auto-decrementation by 1) of internal HD66727 RAM addresses after each data

write can lighten the program load of the MPU.

While an instruction is being executed for internal operation, or during reset, no instruction other than the

busy flag/key scan read instruction can be executed.

Because the busy flag is set to 1 while an instruction is being executed, check it to make sure it is 0 before

sending another instruction from the MPU. If an instruction is sent without checking the busy flag, the time

between the first instruction issue and next instruction issue must be longer than the instruction execution

time itself. Refer to Table 23 for the list of each instruction execution cycles (clock pulses). The execution

time depends on the operating clock frequency (oscillation frequency).

29

Share Link: