MAX188 データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

メーカー

MAX188

Low-Power, 8-Channel, Serial 12-Bit ADCs

Maxim Integrated 

Low-Power, 8-Channel,

Serial 12-Bit ADCs

CS

SSTRB

•••

tSDV

•••

•••

tSTR

•••

tSSTRB

tSSTRB

SCLK

•• • •

• • ••

PD0 CLOCKED IN

Figure 8. External Clock Mode SSTRB Detailed Timing

CS

SCLK

DIN

1 2 345678

START SEL2 SEL1 SEL0

UNI/

DIP

SCL/

DIFF

PD1

PD0

9 10 11 12

SSTRB

DOUT

A/D STATE

tCONV

ACQUISITION CONVERSION

IDLE

10µs MAX

1.5µs (CLK = 2MHz)

B11

MSB

B10

B9

IDLE

18 19 20 21 22 23 24

B2

B1

B0

LSB

FILLED WITH

ZEROS

Figure 9. Internal Clock Mode Timing

Internal Clock

In internal clock mode, the MAX186/MAX188 generate

their own conversion clock internally. This frees the

microprocessor from the burden of running the SAR con-

version clock, and allows the conversion results to be

read back at the processor’s convenience, at any clock

rate from zero to typically 10MHz. SSTRB goes low at the

start of the conversion and then goes high when the con-

version is complete. SSTRB will be low for a maximum of

10µs, during which time SCLK should remain low for best

noise performance. An internal register stores data when

the conversion is in progress. SCLK clocks the data out

at this register at any time after the conversion is com-

plete. After SSTRB goes high, the next falling clock edge

will produce the MSB of the conversion at DOUT, fol-

lowed by the remaining bits in MSB-first format (see

Figure 9). CS does not need to be held low once a con-

version is started. Pulling CS high prevents data from

being clocked into the MAX186/MAX188 and three-

states DOUT, but it does not adversely effect an internal

clock-mode conversion already in progress. When inter-

nal clock mode is selected, SSTRB does not go into a

high-impedance state when CS goes high.

Figure 10 shows the SSTRB timing in internal clock

mode. In internal clock mode, data can be shifted in and

out of the MAX186/MAX188 at clock rates exceeding

4.0MHz, provided that the minimum acquisition time, tAZ,

is kept above 1.5µs.

______________________________________________________________________________________ 13

Share Link: