BR24G04-3(2013) データシートの表示（PDF） - ROHM Semiconductor
部品番号
コンポーネント説明
メーカー
BR24G04-3 Datasheet PDF : 37 Pages
| |||
BR24G04-3
Datasheet
I/O Peripheral Circuit
1. Pull-Up Resistance of SDA Terminal
SDA is NMOS open drain, so it requires a pull up resistor. As for this resistance value (RPU), select an appropriate value
from microcontroller VIL, IL, and VOL-IOL characteristics of this IC. If RPU is large, operating frequency is limited. The
smaller the RPU, the larger is the supply current (Read).
2. Maximum Value of RPU
The maximum value of RPU is determined by the following factors:
(1)SDA rise time to be determined by the capacitance (CBUS) of bus line and RPU of SDA should be tR or lower.
Furthermore, AC timing should be satisfied even when SDA rise time is slow.
(2)The bus’ electric potential ○A to be determined by the input current leak total (IL) of the device connected to the bus
with output of 'H' to the SDA line and RPU should sufficiently secure the input 'H' level (VIH) of microcontroller and
EEPROM including recommended noise margin of 0.2Vcc.
VCC-ILRPU-0.2 VCC ≧ VIH
∴ RPU≦
0.8Vcc－VIH
IL
Ex.) Vcc =3V IL=10µA VIH=0.7 Vcc
From (2)
0.8×3－0.7×3
RPU≦
10×10-6
≦ 30 [kΩ]
Microcontroller
RPU
A
BR24GXX
SDA terminal
IL
IL
Bus line
capacity
CBUS
Figure 44. I/O Circuit Diagram
3. Minimum Value of RPU
The minimum value of RPU is determined by the following factors.
(1) When IC outputs LOW, it should be satisfied that VOLMAX=0.4V and IOLMAX=3mA.
Vcc-VOL
RPU
≦IOL
∴ RPU≧
Vcc－VOL
IOL
(2) VOLMAX=0.4V should secure the input 'L' level (VIL) of microcontroller and EEPROM including recommended
noise margin 0.1Vcc.
VOLMAX ≦ VIL-0.1 VCC
Ex.) VCC =3V, VOL=0.4V, IOL=3mA, microcontroller, EEPROM VIL=0.3Vcc
from (1)
3－0.4
RPU≧ 3×10－3
≧ 867[Ω]
And VOL=0.4［V］
VIL=0.3×3
=0.9［V］
Therefore, the condition (2) is satisfied.
4. Pull-up Resistance of SCL Terminal
When SCL control is made at the CMOS output port, there is no need for a pull up resistor. But when there is a time
where SCL becomes 'Hi-Z', add a pull up resistor. As for the pull up resistor value, one of several kΩ to several ten kΩ is
recommended in consideration of drive performance of output port of microcontroller.
www.rohm.com
©2013 ROHM Co., Ltd. All rights reserved.
TSZ22111･15･001
18/33
TSZ02201-0R2R0G100180-1-2
31.May.2013 Rev.003
Share Link: 