BR24G1MNUX-3AE2(2013) データシートの表示（PDF） - ROHM Semiconductor

部品番号

コンポーネント説明

メーカー

BR24G1MNUX-3AE2
(Rev.:2013)

Serial EEPROM Series Standard EEPROM I2C BUS EEPROM (2-Wire)

ROHM Semiconductor 

BR24Gxxx-3A (128K 256K 1M)

Datasheet

WP Valid Timing (Write Cancel)

WP is usually fixed to 'H' or 'L', but when WP is used to cancel write cycle and so on, pay attention to the following WP valid

timing. During write cycle execution, inside cancel valid area, by setting WP='H', write cycle can be cancelled. In both byte

write cycle and page write cycle, the area from the first start condition of command to the rise of clock to take in D0 of data(in

page write cycle, the first byte data) is the cancel invalid area.

WP input in this area becomes ‘Don't care’. The area from the rise of SCL to take in D0 to the stop condition input is the

cancel valid area. Furthermore, after the execution of forced end by WP, the IC enters standby status..

・Rise of D0 taken clock

SCL

SDA

D1 D0 ACK

Enlarged view

・Rise of SDA

SCL

SDA D0 ACK

Enlarged view

SDA

WP

S

T Slave

A

R address

T

A

C Word

K

L

address

A

C

K

L

A

D7 D6 D5 D4 D3 D2 D1 D0 C

K

L

Data

AS

CT

KO

LP

tWR

WP cancel invalid area

WP cancel valid area WP cancel invalid area

Data is not written.

Figure 47. WP Valid Timing

Command Cancel by Start Condition and Stop Condition

During command input, by continuously inputting start condition and stop condition, command can be cancelled. (Figure

48.) However, within ACK output area and during data read, SDA bus may output 'L'. In this case, start condition and stop

condition cannot be input, so reset is not available. Therefore, execute software reset. When command is cancelled by

start-stop condition during random read cycle, sequential read cycle, or current read cycle, internal setting address is not

determined. Therefore, it is not possible to carry out current read cycle in succession. To carry out read cycle in succession,

carry out random read cycle.

SCL

SDA

1

0

1

0

Start condition Stop condition

Figure 48. Case of Cancel by Start, Stop Condition during Slave Address Input

www.rohm.com

© 2013 ROHM Co., Ltd. All rights reserved.

TSZ22111・15・001

20/35

TSZ02201-0R2R0G100020-1-2

25.Feb.2013 Rev.002

Share Link: