MAX793SCSE(1996) データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
MAX793SCSE Datasheet PDF : 20 Pages
| |||
3.0V/3.3V Adjustable Microprocessor
Supervisory Circuits
have without causing a reset pulse to be issued. As
the amplitude of the transient increases (i.e., goes far-
ther below the reset threshold), the maximum allowable
pulse width decreases. Typically, a VCC transient that
goes 40mV below the reset threshold and lasts for
10µs or less will not cause a reset pulse to be issued.
A 0.1µF bypass capacitor mounted close to the VCC
pin provides additional transient immunity.
Watchdog Software Considerations
There is a way to help the watchdog timer monitor soft-
ware execution more closely, which involves setting
and resetting the watchdog input at different points in
the program rather than “pulsing” the watchdog input
high-low-high or low-high-low. This technique avoids a
“stuck” loop, in which the watchdog timer would con-
tinue to be reset within the loop, keeping the watchdog
from timing out. Figure 19 shows an example of a flow
diagram where the I/O driving the watchdog input is
set high at the beginning of the program, set low at the
beginning of every subroutine or loop, then set high
again when the program returns to the beginning. If
the program should “hang” in any subroutine, the prob-
lem would quickly be corrected, since the I/O is contin-
ually set low and the watchdog timer is allowed to time
out, causing a reset or interrupt to be issued.
_________________Pin Configurations
TOP VIEW
OUT 1
VCC 2
(RESET IN) BATT OK 3
PFI 4
BATT ON 5
GND 6
PFO 7
MR 8
MAX793
MAX794
16 BATT
15 RESET
14 LOWLINE
13 RESET
12 CE OUT
11 CE IN
10 WDI
9 WDO
DIP / Narrow SO
OUT 1
VCC 2
BATT ON 3
GND 4
( ) ARE FOR MAX794
MAX795
DIP/SO
8 BATT
7 RESET
6 CE OUT
5 CE IN
_Ordering Information (continued)
PART*
MAX794CPE
MAX794CSE
MAX794EPE
MAX794ESE
MAX795_CPA
MAX795_CSA
MAX795_EPA
MAX795_ESA
TEMP. RANGE
0°C to +70°C
0°C to +70°C
-40°C to +85°C
-40°C to +85°C
0°C to +70°C
0°C to +70°C
-40°C to +85°C
-40°C to +85°C
PIN-PACKAGE
16 Plastic DIP
16 Narrow SO
16 Plastic DIP
16 Narrow SO
8 Plastic DIP
8 SO
8 Plastic DIP
8 SO
* The MAX793/MAX795 offer a choice of reset threshold voltage.
Select the letter corresponding to the desired reset threshold volt-
age range (T = 3.00V to 3.15V, S = 2.85V to 3.00V, R = 2.55V
to 2.70V) and insert it into the blank to complete the part number.
The MAX794’s reset threshold is adjustable.
___________________Chip Information
TRANSISTOR COUNT: 1271
______________________________________________________________________________________ 19
Share Link: 