ELM322 データシートの表示（PDF） - Elm Electronics

部品番号

コンポーネント説明

メーカー

ELM322

OBD (VPW) to RS232 Interpreter

Elm Electronics 

ELM322

Absolute Maximum Ratings

Storage Temperature....................... -65°C to +150°C

Ambient Temperature with

Power Applied....................................-40°C to +85°C

Voltage on VDD with respect to VSS............ 0 to +7.5V

Voltage on any other pin with

respect to VSS........................... -0.6V to (VDD + 0.6V)

Note:

Stresses beyond those listed here will likely damage

the device. These values are given as a design

guideline only. The ability to operate to these levels

is neither inferred nor recommended.

Electrical Characteristics

All values are for operation at 25°C and a 5V supply, unless otherwise noted. For further information, refer to note 1 below.

Characteristic

Minimum Typical Maximum Units

Conditions

Supply voltage, VDD

4.5

5.0

5.5

V

VDD rate of rise

0.05

V/ms see note 2

Average supply current, IDD

1.0

2.4

mA see note 3

Input low voltage

VSS

0.15 VDD

V

Input high voltage

0.85 VDD

VDD

V

Output low voltage

0.6

V Current (sink) = 8.7 mA

Output high voltage

Rx pin input current

VDD - 0.7

-0.5

V Current (source) = 5.4 mA

+0.5

mA see note 4

RS232 baud rate

9600

baud see note 5

Notes:

1. This integrated circuit is produced with a Microchip Technology Inc.’s PIC12C509A as the core embedded

microcontroller. For further device specifications, and possibly clarification of those given, please refer to the

appropriate Microchip documentation (available at http://www.microchip.com/).

2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved

using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as

may be obtained through direct connection to solar cells, or some charge pump circuits.

3. Device only. Does not include any load currents.

4. This specification represents the current flowing through the internal protection diodes when the voltage

connected to the Rx input (through a current limiting resistance) is greater than VDD or less than VSS.

Currents quoted are the maximum that should be allowed to flow continuously.

5. Nominal data transfer rate when a 3.58 MHz crystal is used as the frequency reference. Data is transferred

to and from the ELM322 with 8 data bits, no parity, and 1 stop bit (8 N 1).

ELM322DSF

Elm Electronics – Circuits for the Hobbyist

< http://www.elmelectronics.com/ >

3 of 18

Share Link: