73M223 データシートの表示（PDF） - TDK Corporation

部品番号

コンポーネント説明

メーカー

73M223

1200 Baud FSK Modem

TDK Corporation 

73M223

1200 Baud FSK Modem

FUNCTIONAL DESCRIPTION

The 73M223 has four main functional sections:

timing, transmit, receive, and test. Each section of

the chip will be individually described below.

TIMING

The timing section contains the oscillator (OSC) and

logic which generates digital timing signals used

throughout the chip. The time base can be derived

from 3.18 MHz crystal or an external digital input.

The digital timing logic divides the oscillator

frequency to give a 1200 Hz output than can be

used for system timing. The signaling frequencies

are 1302 Hz for logic “1” and 2097 Hz for logic “0.”

The modem will operate with clock inputs from 330

kHz to 7.0 MHz. However, the signaling frequencies

and the system timing will be directly proportional to

the difference in clock frequency.

TRANSMITTER

The 73M223 transmitter consists of a programmable

divider that drives a coherent phase frequency

synthesizer. The programmable divider is digitally

controlled via the Data Input pin (TXD). The output

of the divider clocks a 16 segment phase coherent

frequency synthesizer. A sine wave is constructed

by eight weighted capacitors which are the inputs to

a low pass filter. The synthesized signal is output

directly to the transmit pin TXA. The transmit signal

can be disabled by using the digital control pin 7;.

RECEIVER

The 73M223’s receiver is comprised of three

sections: the input bandpass filter, the

synchronization loop, and the demodulator.

The input bandpass filter is a four pole Butterworth

filter, implemented using switched capacitor

technology. This filter reduces wideband noise which

significantly improves data error rates. The 73M223

can be configured with the bandpass filter in series

with the receiver by setting FIL = 1 and inserting the

received signal at RXF (recommended

configuration). The bandpass filter can be deleted

from the system by setting FIL = 0 and inputting the

received signal through RXA.

The demodulator is used to detect a received mark

or space.

The synchronization for sampling the digital output at

RXD is derived from a digital phase locked loop. The

phase locked loop is clocked at 16 times the bit rate

with a maximum lock period of 8 clocks to lock on

the data output signal. When 6<1 is low the output

of SYNC is nominally 1200 Hz, but is resynchronized

to the center of the data bit on each data transition.

When 6<1 is high, SYNC will output a 1200 Hz

clock, which is not synchronized to the data on RXD.

SELF TEST MODE

The 73M223 features an autotest mode which

provides easy field test capability of the chip’s

functionality. The modem is placed in the test mode

by taking the test pin high. In the test mode the Data

Input pin is disconnected and the programmable

divider is driven by a pseudo random PN sequence

generator and the transmitter’s output is connected

to the receiver’s input. The input data to the

programmable divider is delayed by the system

delay time and compared to the digital output on

sync transitions. If the detected data matches the

delayed input data from the PN sequence counter,

the 73M223 is properly functioning as indicated by

RXD low. A high on the RXD pin indicates a

functional problem on the 73M223.

2

Share Link: