QPP-026 データシートの表示（PDF） - Xemod -> Mprise
部品番号
コンポーネント説明
メーカー
QPP-026 Datasheet PDF : 3 Pages
| |||
Performance at 28VDC & 25ºC (continued)
Parameter
2nd Harmonic at 200W Pout(single tone)
3rd Harmonic at 200W Pout(single tone)
Group (Signal) Delay
Transmission Phase Flatness
Symbol
Min
τd
RMS EVM at 100W EDGE Pout
Performance at 28VDC Over Temperature
Parameter
Peak Envelope Power at 1 dB Compression (two-tone)
Gain at 200W PEP (two tone)
Symbol
Min
P-1
200
Gain Variation over frequency at 200W Output (single tone)
∆G
Input Return Loss (50 Ω Ref) at 40W PEP (two tone)
IRL
Drain Efficiency at 200W PEP (two tone)
η
3rd Order IMD Product (2 tone at 200W PEP;1 MHz spacing)
Group (Signal) Delay
τd
Nom
4.0
0.5
1.5
Max
1.5
2.0
Units
dBc
dBc
ns
degrees
%
Nom
Max
Units
W
dB
dB
%
dBc
0.5
1.5
ns
Notes:
This GR-version QuikPAC module has an internally regulated gate voltage that is preset at the factory. A voltage of
+12VDC (±1V) should be applied to each gate lead (pins 1 and 5 ). No further adjustment is required. The gate voltage is
thermally compensated for operation over the temperature range listed in the data sheet. Although the module will
operate with lower voltages applied, the internal regulator is not functioning and the specified performance may not be
achieved.
Gate voltage must be applied coincident with or after application of the drain voltage to prevent potentially destructive
oscillations. Bias voltages should never be applied to a module unless it is terminated on both input and output.
The quiescent current set during manufacture will be within the range specified in the Performance section (nominal
±10%) and is selected to balance IMD, input return loss, and efficiency. This setting is suitable for most applications.
Modules with different optimization profiles are available by special order.
Internal RF decoupling is included on all bias leads. No additional bypass elements are required, however some
applications may require energy storage on the drain leads to accommodate time-varying waveforms.
The RF leads are internally protected against DC voltages up to 100V. Care should be taken to avoid video transients that
may damage the active devices.
Xemod QuikPAC Data
QPP-026
www.xemod.com
Rev. C (6-5-02) Page 2 of 3
Share Link: 