NJM3717D2 データシートの表示（PDF） - Japan Radio Corporation
部品番号
コンポーネント説明
メーカー
NJM3717D2 Datasheet PDF : 10 Pages
| |||
NJM3717
s Applications Information
Motor selection
Some stepper motors are not designed for continuous operation at maximum current. As the circuit drives a con-
stant current through the motor, its temperature can increase, both at low- and high-speed operation.
Some stepper motors have such high core losses that they are not suited for switched-mode operation.
Interference
As the circuit operates with switched-mode current regulation, interference-generation problems can arise in some
applications. A good measure is then to decouple the circuit with a 0.1 µF ceramic capacitor, located near the
package across the power line VMM and ground.
Also make sure that the VR input is sufficiently decoupled. An electrolytic capacitor should be used in the +5 V rail,
close to the circuit.
The ground leads between RS, CC and circuit GND should be kept as short as possible. This applies also to the
leads connecting RS and RC to pin 16 and pin 10 respectively.
In order to minimize electromagnetic interference, it is recommended to route M and M leads in parallel on the
A
B
printed circuit board directly to the terminal connector. The motor wires should be twisted in pairs, each phase
separately, when installing the motor system.
Unused inputs
Unused inputs should be connected to proper voltage levels in order to obtain the highest possible noise immunity.
Ramping
A stepper motor is a synchronous motor and does not change its speed due to load variations. This means that the
torque of the motor must be large enough to match the combined inertia of the motor and load for all operation
modes. At speed changes, the requires torque increases by the square, and the required power by the cube of the
speed change. Ramping, i.e., controlled acceleration or deceleration must then be considered to avoid motor pull-
out.
VCC , VMM
The supply voltages, V and V , can be turned on or off in any order. Normal dV/dt values are assumed.
CC
MM
Before a driver circuit board is removed from its system, all supply voltages must be turned off to avoid destruc-
tive transients from being generated by the motor.
VCC (+5 V)
V MM
Phase A
I
1A
I
0A
11
6
3, 14
8
V
Phase R
VV
1
CC MM M
7I
9
1
I
NJM3717
0
B
M 15
A
T GND C
E
2
4, 5 10
16
12, 13
56 kΩ
1 kΩ
820 pF
820 pF
1Ω
STEPPER
MOTOR
VCC (+5 V)
V MM
Phase B
I
1B
I
0B
11
6
3, 14
8
V
Phase R
VV
1
CC MM M
7I
9
1
I
0
NJM3717
B
M 15
A
T GND C
E
2
4, 5 10
16
12, 13
56 kΩ
1 kΩ
820 pF
820 pF
1Ω
Figure 8. Typical stepper motor driver application with NJM3717
Share Link: 