PU200-10 データシートの表示（PDF） - International Power DC Power Supplies
部品番号
コンポーネント説明
メーカー
PU200-10 Datasheet PDF : 2 Pages
| |||
GENERAL SPECIFICATIONS
All specifications are typical at nominal line, full load, and 25°C.
Efficiency:
Hold-up time:
Line regulation:
Inrush current:
Safety ground
leakage current:
Withstand voltage:
Operating temperature:
Storage temperature:
Mean time between
failure:
EMI requirements:
Safety requirements:
Power Fail Detect
(PFD SIGNAL)
70% typical at 200W output
20 msec minimum at 110 VAC input
±0.5% maximum at full load
60A maximum at cold start
0.35mA max. @ 110VAC. 60Hz
0.63mA max. @ 240VAC. 50Hz
3000 VAC from input to output
1500 VAC from input to ground
0 to 70°C*
-40 to +85°C
85,000 hours at full load
at 25°C ambient
Meets conduction limits of
a) FCC 20780 Level B
b) CISPR 22 (EN 55022) Level B
Meets or exceeds:
a) UL 1950
b) CSA C22.2 No. 234
c) IEC 950
TTL logic high for normal operation
and TTL logic low upon loss of input
power. This signal appears at least
1mS prior to 5V output dropping 5%
below its nominal value. This signal
also provides a minimum delay of 100
mS after +5V is within regulation.
MECHANICAL SPECIFICATIONS
NOTES:
1. Dimensions shown in inches [mm]
2. Tolerance 0.02 [0.5] maximum
3. Input connector P1 is Beau Inc. P/N
72-5-03C, output connector P2 is
Beau Inc. P/N 72-5-09C. Screws are
#6-32 on 0.375 inch centers.
4. Connector P3 mates with Molex
housing 22-01-1043 and Molex
40445 series crimp terminal.
5. Weight:
1.25 Kgs (2.8 Lbs) approx.
for "B" version.
1.50 Kgs (3.3 Lbs) approx.
for "C" version.
P1
1-Line
2-Neutral
3-Ground
INPUT SPECIFICATIONS
Input voltage:
90 to 130 VAC, 180 to 264 VAC
Input frequency:
47 to 440 Hz
Input current:
4.5A (rms) for 115 VAC
2.6A (rms) for 230 VAC
OUTPUT SPECIFICATIONS
Output voltage:
Output current:
Output power range:
Ripple and noise:
Overvoltage protection:
Overcurrent protection:
Temperature coefficient:
Transient response:
Cooling:
See Rating Chart
See Rating Chart
See Note#3 on front of data sheet
2% peak to peak maximum
Provided on output #l only: set at
112-132% of its nominal
output voltage
All outputs protected to short
circuit conditions
All outputs ±0.04%/°C maximum
Maximum excursion of 4% or
better on all models recovering to
1% of final value within 500us after
a 25% step load change
25 CFM forced air provided on
"C" version to be provided by user
on "B" version.
* Derate linearly from 100% load at 50°C to 50% load at 70°C
PIN CHART
Model
PIN
PU200-10, PU200-12
PU200-13, PU200-14
PU200-16, PU200-18
1, 2
-SENSE
PU200-23, PU200-24
PU200-25
OUTPUT
#1
PU200-30, PU200-31
PU200-32
OUTPUT
#1
PU200-40, PU200-41
PU200-42, PU200-44
PU200-45
OUTPUT
#1
3, 4, 5
RET.
COM.
RET.
COM.
RET.
COM.
RET.
6
OUTPUT
#1
P2
7
OUTPUT
#1
8
OUTPUT
#1
9
+SENSE
OUTPUT
#2
OUTPUT
#2
OUTPUT
#2
N.C.
OUTPUT
#3
OUTPUT
#3
N.C.
N.C.
OUTPUT
#4
RETURN
N. C.
N.C.
OUTPUT
#4
1
P.F.D.
P.F.D.
P.F.D.
P.F.D.
P3
2
3
4
COM. COM.
FAN
RET.
RET.
COM. COM.
FAN
RET.
RET.
COM. COM.
RET.
RET.
FAN
COM. COM.
FAN
RET.
RET.
International
Power Sources, Inc.
Your Source of Power ...
260 Hopping Brook Road, Holliston, MA 01746
TEL: (508) 429-4440 FAX: (800) 226-2100
77
http://www.intlpower.com
Share Link: 