PIC16C505T-20/SL データシートの表示（PDF） - Microchip Technology

部品番号

コンポーネント説明

メーカー

PIC16C505T-20/SL

14-Pin, 8-Bit CMOS Microcontroller

Microchip Technology 

4.6 Program Counter

As a program instruction is executed, the Program

Counter (PC) will contain the address of the next

program instruction to be executed. The PC value is

increased by one every instruction cycle, unless an

instruction changes the PC.

For a GOTO instruction, bits 8:0 of the PC are provided

by the GOTO instruction word. The PC Latch (PCL) is

mapped to PC<7:0>. Bit 5 of the STATUS register

provides page information to bit 9 of the PC

(Figure 4-3).

For a CALL instruction, or any instruction where the

PCL is the destination, bits 7:0 of the PC again are

provided by the instruction word. However, PC<8>

does not come from the instruction word, but is always

cleared (Figure 4-3).

Instructions where the PCL is the destination, or

Modify PCL instructions, include MOVWF PC, ADDWF

PC, and BSF PC,5.

Note:

Because PC<8> is cleared in the CALL

instruction or any Modify PCL instruction,

all subroutine calls or computed jumps are

limited to the first 256 locations of any pro-

gram memory page (512 words long).

FIGURE 4-3:

LOADING OF PC

BRANCH INSTRUCTIONS -

PIC16C505

GOTO Instruction

11 10 9 8 7

0

PC

PCL

Instruction Word

PA0

7

0

STATUS

CALL or Modify PCL Instruction

11 10 9 8 7

0

PC

PCL

Instruction Word

Reset to ‘0’

PA0

7

0

STATUS

PIC16C505

4.6.1 EFFECTS OF RESET

The Program Counter is set upon a RESET, which

means that the PC addresses the last location in the

last page (i.e., the oscillator calibration instruction.)

After executing MOVLW XX, the PC will roll over to

location 00h and begin executing user code.

The STATUS register page preselect bits are cleared

upon a RESET, which means that page 0 is pre-

selected.

Therefore, upon a RESET, a GOTO instruction will

automatically cause the program to jump to page 0

until the value of the page bits is altered.

4.7 Stack

PIC16C505 devices have a 12-bit wide hardware

push/pop stack.

A CALL instruction will push the current value of stack

1 into stack 2 and then push the current program

counter value, incremented by one, into stack level 1. If

more than two sequential CALL’s are executed, only

the most recent two return addresses are stored.

A RETLW instruction will pop the contents of stack level

1 into the program counter and then copy stack level 2

contents into level 1. If more than two sequential

RETLW’s are executed, the stack will be filled with the

address previously stored in level 2. Note that the

W register will be loaded with the literal value specified

in the instruction. This is particularly useful for the

implementation of data look-up tables within the

program memory.

Note 1: There are no STATUS bits to indicate

stack overflows or stack underflow condi-

tions.

Note 2: There are no instructions mnemonics

called PUSH or POP. These are actions that

occur from the execution of the CALL,

RETLW, and instructions.

© 1999 Microchip Technology Inc.

DS40192C-page 17

Share Link: