ATEMGA128-16AN データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATEMGA128-16AN

8-bit Atmel Microcontroller with 128KBytes In-System Programmable Flash

Atmel Corporation 

RESET

XTAL1

XTAL2

AVCC

AREF

PEN

ATmega128

In ATmega103 compatibility mode, these pins only serves as strobes signals to the external

memory as well as input to the 32kHz Oscillator, and the pins are initialized to PG0 = 1, PG1 = 1,

and PG2 = 0 asynchronously when a reset condition becomes active, even if the clock is not

running. PG3 and PG4 are oscillator pins.

Reset input. A low level on this pin for longer than the minimum pulse length will generate a

reset, even if the clock is not running. The minimum pulse length is given in Table 19 on page

50. Shorter pulses are not guaranteed to generate a reset.

Input to the inverting Oscillator amplifier and input to the internal clock operating circuit.

Output from the inverting Oscillator amplifier.

AVCC is the supply voltage pin for Port F and the A/D Converter. It should be externally con-

nected to VCC, even if the ADC is not used. If the ADC is used, it should be connected to VCC

through a low-pass filter.

AREF is the analog reference pin for the A/D Converter.

PEN is a programming enable pin for the SPI Serial Programming mode, and is internally pulled

high . By holding this pin low during a Power-on Reset, the device will enter the SPI Serial Pro-

gramming mode. PEN has no function during normal operation.

7

2467XS–AVR–06/11

Share Link: