D16550 データシートの表示（PDF） - Unspecified

部品番号

コンポーネント説明

メーカー

D16550

Configurable UART with FIFO

Unspecified 

APPLICATIONS

● Serial Data communications applications

● Modem interface

KEY FEATURES

● Software compatible with 16450 and

16550 UARTs

● Configuration capability

● Separate configurable BAUD clock line

● Two modes of operation: UART mode and

FIFO mode

● Majority Voting Logic

● In the FIFO mode transmitter and receiver

are each buffered with 16 byte FIFO to

reduce the number of interrupts presented

to the CPU

● Adds or deletes standard asynchronous

communication bits (start, stop, and parity)

to or from the serial data

● In UART mode receiver and transmitter

are double buffered to eliminate a need for

precise synchronization between the CPU

and serial data

● Independently controlled transmit, receive,

line status, and data set interrupts

● False start bit detection

● 16 bit programmable baud generator

● MODEM control functions (CTS, RTS,

DSR, DTR, RI, and DCD)

● Fully programmable serial-interface

characteristics:

○ 5-, 6-, 7-, or 8-bit characters

○ Even, odd, or no-parity bit generation and

detection

○ 1-, 1½-, or 2-stop bit generation

○ Baud generation

● Complete status reporting capabilities

● Line break generation and detection.

Internal diagnostic capabilities:

○ Loop-back controls for communications link

fault isolation

○ Break, parity, overrun, framing error

simulation

● Two DMA Modes allows single and multi-

transfer

All trademarks mentioned in this document

are trademarks of their respective owners.

● Technology independent HDL Source

Code

● Full prioritized interrupt system controls

● Fully synthesizable static design with no

internal tri-state buffers

OPTIONAL FEATURES

● IEEE 1284 Bidirectional Parallel Data Port

○ Compatible with Standard Centronics

Parallel Interface

○ Support for Parallel Protocols: ECP and EPP

○ Data Path 16-Byte FIFO Buffer

○ Direct Memory Access (DMA) Transfer

○ Decompression of Run Length Encoded

Data in ECP Reserve Mode

○ Direct Connection to Printer, No External

Transceiver is needed

● Serial Ports with Infrared Data Association

(IRDA) inputs and outputs

DESIGN FEATURES

The functionality of the D16550 core was

based on the Texas Instruments TL16C550A.

The following characteristics differentiate the

D16550 from Texas Instruments devices:

● The bi-directional data bus has been split

into two separate buses: datai(7:0),

datao(7:0)

● Signals rd2 and wr2, xin, and xout have

been removed from interface

● Signal ADS and address latch have been

removed

● The DLL, DLM and THR registers are

reset to all zeros

● TEMT and THRE bits of Line Status

Register, are reset during the second

clock rising edge following a THR write

● RCLK clock is replaced by global clock

CLK, internally divided by BAUD factor.

● Asynchronous microcontroller interface is

replaced by equivalent Universal interface

● All latches implemented in original 16550

devices are replaced by equivalent flip-flop

registers, with the same functionality

http://www.DigitalCoreDesign.com

http://www.dcd.pl

Copyright 1999-2009 DCD – Digital Core Design. All Rights Reserved.

Share Link: