MPU-6050 データシートの表示（PDF） - Unspecified
部品番号
コンポーネント説明
メーカー
MPU-6050 Datasheet PDF : 13 Pages
| |||
MPU-6000/MPU-6050 EV Board User Guide
Document Number: AN-MPU-6000EVB-00
Revision: 01
Release Date: 1/12/2011
2. Purpose
This document describes the hardware and circuitry on the MPU-6000 and MPU-6050 (collectively
called the MPU-60X0) 9-Axis Evaluation (EV) Board. This EVB is used for evaluating the MPU-6000
and MPU-6050. It covers applying the EV board to a larger system, understanding key signals and
circuit functions, hardware jumper settings, and port connectors.
2.1 Usage
This evaluation board provides nine axes of motion sensing, comprised of:
• Digital-output X-, Y-, and Z-Axis angular rate sensors (gyroscopes) with a user-
programmable full-scale range of ±250, ±500, ±1000, and ±2000°/sec
• Digital-output tri-axis accelerometer with a programmable full scale range of ±2g, ±4g,
±8g and ±16g
• Digital-output tri-axis compass with a full scale range of ±1200µT
• Data is measured using on-chip ADCs and is transmitted over I²C or SPI interfaces.
The Evaluation board may be used by itself using SPI or I²C serial communications interfaces.
Alternatively, it may be connected to InvenSense’s ARM Evaluation Board (INVARMEVB) for
connectivity to a host computer using a USB interface.
2.2 Related Documents
The following documents are recommended for more fully understanding the products and
systems described in this documents.
• MPU-6000 Product Specification
• AK8975/AK8975C Datasheet
3. MPU-6000 9-Axis EV Board Overview
The MPU-6000 9-Axis EV Board contains the MPU-6000 digital Motion Processing Unit and the AKM
compass. Additionally, it contains a number of ‘solder-across’ jumper points that permit several circuit
configurations.
Please refer to Figures 1 & 5. The EV Board is populated on its top side only for ease of measurement
access. The 10x2 customer header connector (JP14) is designed to connect with the InvenSense ARM
Evaluation Board (INVARMEVB), which is a host microcontroller board useful for adapting the MPU-
6000 9-Axis EV Board to a personal computer via its USB port.
The 5x2 extension factory header (JP13) is intended for connecting additional devices to the EV Board,
such as a camera image stabilization processor, or a digital-output compass, etc. The 3-pin power
selection header (JP12) is used to select which voltage supply is fed to the MPU-6000. The 3-pin
VLOGIC selection header (JP6) is used to select between 3 V and VDD as the logic supply voltage.
InvenSense, Inc., 1197 Borregas Ave., Sunnyvale, Ca 94089, USA
4
Tel: +1 (408) 988-7339 Fax: +1 (408) 988-8104
Website: http//www.invensense.com
AN-MPU-6000EVB-00
©2011 InvenSense, Inc. All rights reserved.
Share Link: 