6EP1321-1SH03 データシートの表示（PDF） - Siemens AG

部品番号

コンポーネント説明

メーカー

6EP1321-1SH03

Power supply LOGO!Power

Siemens AG 

Mounting/Disassembly

2

WARNING

The LOGO!Power power supplies are built-in units. They must be installed in a casing or

control cabinet to which only qualified personnel have access.

The devices can be snapped onto standard mounting rail EN 60715 35x7.5/15 for installation

in a control cabinet.

Installation

To mount the device, position it with the mounting rail guideway at the upper edge of the DIN

rail and press down to lock it into place. If this is too difficult, press slider ① at the same

time, as described for "Disassembly".

Deinstalling

To remove, pull up the slider ① using a screwdriver ② and disengage the device at the

bottom edge of the DIN rail. Then you can remove the device from the upper edge of the DIN

rail.

Figure 2-1 Deinstalling

WARNING

If the device is to be used in a hazardous area (Ex II 3G Ex nA IIC T3) it must be installed

in a distributor box with degree of protection IP54 or higher.

LOGO!Power

Operating Instructions, 02.2011, C98130-A7560-A999-1-7619

13

Share Link: